BlueOptics 470-ACOR-BO InfiniBand Fibre Optic Cable 3m QSFP Aqua

The BlueOptics 470-ACOR-BO InfiniBand Fibre Optic Cable 3m QSFP Aqua is a 3-meter active optical cable (AOC) with QSFP-to-QSFP connectors designed for high-speed 40 Gbps links in data center and enterprise networking environments. Engineered to meet MSA standards, this aqua-coloured multi-mode fibre AOC integrates transceivers at each end for optical transmission and reception, supporting protocols such as Ethernet, Fibre Channel over Ethernet and SDH/SONET at line rates up to 40 Gbps over a 3 m channel. The cable is intended for straightforward, pre-assembled connections between compatible switches, routers and storage systems without the need for separate patch cords.

Advantages

This QSFP AOC provides plug-and-play connectivity with a pre-terminated, factory-tested assembly that reduces the need for field terminations and cleaning of patch cords. Compliance with industry MSA specifications and the use of quality optical and electronic components contribute to consistent signal integrity and long operational lifetime. Integrated digital diagnostic monitoring (DDM/DOM) enables real-time readout of parameters such as supply voltage, laser bias current, transmit/receive optical power and temperature where supported by the host hardware. The active optical design reduces susceptibility to electromagnetic interference while enabling high bandwidth and low latency over short to medium server-room distances.

Suitable for

• 40 Gbps uplinks between QSFP-enabled switches
• Interconnects for storage systems and SAN equipment supporting 40G AOC
• Short-reach InfiniBand or Ethernet high-speed links in data centers
• Environments requiring immunity to electromagnetic interference

Key specifications

• Cable type: Active Optical Cable (AOC) with QSFP to QSFP connectors
• Length: 3 meters
• Data rate: up to 40 Gbps aggregate
• Fiber type: multimode optical fiber
• Form factor: QSFP (Quad Small Form-factor Pluggable)
• Colour: aqua
• Digital diagnostics: DDM/DOM support (when supported by host hardware)

How to use

Install the BlueOptics 3 m QSFP AOC by inserting each QSFP connector firmly into QSFP ports on the source and destination devices while the devices are powered according to the vendor’s guidelines. Ensure both endpoints support the required 40G line rate and any host software restrictions for third-party AOCs. Use the host system’s management interface to verify link state and, if available, to read digital diagnostic values. Route the cable to avoid tight bends and mechanical stress; follow device vendor recommendations for port handling and hot-plug procedures.

Recommendations

Verify compatibility with the specific switch, router or storage platform before deployment and check that the platform supports DDM/DOM if you plan to use diagnostic monitoring. Avoid sharp bends and compressive forces on the cable; maintain recommended bend radius for multimode fibre and keep connector ends dust-free during installation.