Akasa SATA to 4‑pin Molex Adapter AK‑CBPW03‑KT02 15 cm cable, pack of 2

Akasa SATA to 4‑pin Molex Adapter AK‑CBPW03‑KT02 15 cm cable, pack of 2 converts a SATA power output into a legacy 4‑pin Molex power connector. The pair of adapters each features a 15 cm cable that allows flexible placement inside a PC case and enables powering older drives or peripherals from modern power supply units that provide SATA power lines. The compact design supports internal cable routing and makes it easier to reuse Molex‑powered devices during upgrades or repairs.

Advantages

This adapter pack provides a simple and reversible method to obtain a 4‑pin Molex power connection from an available SATA power plug without soldering or modifying cables. The 15 cm lead gives enough length for convenient routing behind drive bays or along case edges. Sold as a pair, the kit supports multiple devices or provides a spare. The adapters maintain standard pin assignments and are suitable for typical PC voltages and currents associated with peripheral power.

Suitable for

• Powering legacy hard drives, optical drives or fans that use 4‑pin Molex from SATA power
• PC upgrades where Molex‑only peripherals need to be connected to a PSU with available SATA power
• Internal cable management and neat routing in desktop computer cases
• Repair situations where original Molex cables are missing or damaged

Key specifications

• Connector conversion: SATA power (female) to 4‑pin Molex (male)
• Cable length: 15 cm per adapter
• Quantity: pack of 2 adapters
• Compatible voltages: standard ATX peripheral voltages (5 V and 12 V)
• Form factor: inline adapter with molded housings for connectors

How to use

Disconnect power from the computer before installation. Insert the SATA power plug from the power supply into the SATA receptacle on the adapter, then connect the 4‑pin Molex male plug to the target peripheral or drive. Ensure connectors are fully seated and that wiring is not strained by sharp bends. Restore power and verify the peripheral receives power and operates normally.

Recommendations

Use these adapters only for powering devices designed for 4‑pin Molex input and within the current limits of a single SATA power line. Avoid daisy‑chaining multiple high‑current devices from one SATA connector, and route cables to prevent pin stress or connector misalignment. If a device draws unusually high current or shows instability, stop use and consult the device documentation or consider direct PSU cables designed for high current loads.