Wire puller DELOCK for active optical cable, black, width 20 mm, depth 113 mm, min bending radius 5 mm

DELOCK wire puller for active optical cable is a compact installation accessory designed to support safe routing and pulling of active optical fibers in confined spaces. The tool comes in black and measures 20 mm in width, 113 mm in depth and 17 mm in height, with a minimum bending radius of 5 mm. It is intended to protect connector ends and the cable jacket during passage through ducts, conduits and tight openings, reducing stress on the fiber and simplifying handling during setup and maintenance.

Advantages

The wire puller provides a firm and low-profile guide that helps preserve connector integrity and prevents sharp bends near the termination. Its compact dimensions enable use in narrow ducts and tight access points, while the built-in fastening points accept cable ties for secure attachment and repeated use. The product’s minimum bending radius specification ensures that pulled active optical cables maintain appropriate curvature to reduce risk of signal degradation or fiber damage.

Suitable for

• Routing and pulling active optical cables through conduit and ductwork
• Installation and maintenance in rack and cabinet systems with limited space
• Protecting connectors and cable jackets when feeding cables through tight openings
• Temporary attachment points where a reusable pull aid is required

Key specifications

• Color: black
• Width: 20 mm
• Depth: 113 mm
• Height: 17 mm
• Minimum bending radius: 5 mm
• Fastening method: cable tie compatible fastening points

How to use

Attach the wire puller to the cable near the connector using an appropriate cable tie through the provided fastening points. Ensure the cable follows the guide profile and avoid forcing tight bends beyond the specified minimum bending radius. Feed the cable through the conduit or duct while maintaining gentle, even tension on the puller. After the cable is in place and the connector has passed through the obstruction, cut and remove the cable tie and detach the puller for reuse.

Recommendations

Do not exceed the minimum bending radius of 5 mm for the active optical cable; maintain steady pulling tension and use additional guides or lubricant when navigating multiple bends or long conduit runs. Inspect connectors and the cable jacket after pulling to verify there is no visible damage before finalizing the installation.