Telephone cable ShiverPeaks 76860-25 6x2x0.6 mm round — for in-wall installation

Round telephone cable ShiverPeaks 6x2x0.6 mm for in-wall installation is a compact multi-pair cable designed for fixed telephone and low-voltage signal wiring in residential and office environments. The cable contains six twisted pairs of conductors with a 0.6 mm conductor diameter and a round outer profile that simplifies routing through conduits, junction boxes and wall cavities. It is intended for voice communication and basic data or signaling applications where a standardized, space-saving cable geometry is required.

Advantages

The round construction and grouped twisted pairs provide organized pair separation and consistent electrical characteristics across pairs. With 0.6 mm conductors the cable balances mechanical flexibility and reliable contact performance for standard telephone terminations. Its design for in-wall installation reduces bulk in enclosed spaces and makes it easier to pull and terminate compared with flat cable alternatives. The cable is suitable for installations where neat routing and compatibility with conventional telephone connectors and blocks are needed.

Suitable for

• Fixed landline telephone wiring in homes and offices
• Low-voltage signal and intercom connections
• Internal cabling inside wall cavities and conduit runs
• Basic voice and low-speed data links for telephony equipment

Key specifications

• Cable geometry: round profile with grouped pairs
• Number of conductors: 6 pairs (12 conductors)
• Conductor diameter: 0.6 mm
• Conductor material: copper (solid or stranded depending on variant)
• Insulation: pair insulation suitable for low-voltage telephone applications
• Intended use: fixed in-wall installation
• Typical applications: voice, basic data signalling, intercoms

How to use

Install the cable inside walls or conduits following local building and electrical codes for low-voltage wiring. Route the cable from the distribution point to the termination locations, avoiding sharp bends and excessive pulling tension. Strip the outer sheath and separate the required pair(s) for termination, then terminate on standard telephone connectors, modular jacks or terminal blocks designed for 0.6 mm conductors. Secure and label runs as needed to maintain organized wiring and facilitate future maintenance.

Recommendations

For reliable performance, avoid running the cable in parallel with high-voltage power lines to reduce potential interference. Use appropriate grommets and protection where the cable passes through sharp-edged openings, and follow recommended bend radii to prevent conductor damage. For installations with higher bandwidth or data requirements, evaluate dedicated data cabling solutions instead of telephone cable.