Networking Cable S/CONN 75217 Grey 7.5 m Cat5e SF/UTP

The S/CONN 75217 Grey 7.5 m Cat5e SF/UTP networking cable is a 7.5-metre Ethernet patch lead designed for wired network connections. Constructed to Cat5e specification with SF/UTP shielding, this cable supports data transfer rates up to 1000 Mbit/s and comes fitted with RJ-45 connectors on both ends. The grey outer jacket provides a neutral appearance suitable for office or home installations.

Advantages

SF/UTP shielding reduces electromagnetic interference and crosstalk compared with unshielded cables, improving signal integrity in environments with nearby electrical equipment. Cat5e performance supports Gigabit Ethernet at typical local area network distances, and the molded RJ-45 connectors ensure a reliable, low-resistance connection. The 7.5 m length offers flexibility for setups where devices are separated by moderate distances while maintaining a tidy cable run.

Suitable for

• Connecting desktop PCs, switches and routers within home or small office networks
• Wiring networked printers, network-attached storage (NAS) and media players
• Temporary or permanent patching of wall ports and structured cabling runs up to 7.5 metres

Key specifications

• Cable category: Cat5e
• Shielding: SF/UTP (foil with braided drain plus unshielded twisted pairs)
• Length: 7.5 m
• Connectors: RJ-45 plug on both ends (8P8C)
• Maximum supported throughput: up to 1000 Mbit/s (Gigabit Ethernet)
• Outer jacket colour: grey

How to use

Plug one RJ-45 connector into the Ethernet port of your device and the other into the corresponding port on your switch, router or wall socket. Ensure connectors are fully inserted until the latch clicks to secure the connection. Route the cable to avoid tight bends and pinching; maintain a gentle bend radius and avoid running parallel to high-voltage power lines to reduce potential interference. For best performance, use this cable within typical horizontal cabling distances and in environments compatible with Cat5e specifications.

Recommendations

For stable Gigabit performance, verify that connected devices and intermediate network hardware support 1000 Mbit/s. In environments with high electromagnetic interference, confirm proper grounding of shielded outlets and patch panels to make use of the SF/UTP shielding. Replace the cable if the outer jacket is damaged or if connectors show visible wear.