SATA Cable DeLOCK 84991 0.5m SATA 7-pin Black Blue

This SATA cable by Delock enables internal connection of SATA devices such as HDDs, controller cards or flash memories. It supports the SATA III standard with a data transfer rate of up to 6 Gb/s and is backward compatible with earlier SATA versions. The cable is 0.5 m long and comes in a black and blue design; when connected to a hard drive the cable is guided to the right. Metal clips on the connectors secure the connection by clicking the cable into place.

Advantages

The DeLOCK 84991 cable offers SATA III performance up to 6 Gb/s while remaining compatible with older SATA interfaces. Its 7-pin connectors on both ends provide a standard fit for motherboards, controller cards and drives. The metal retaining clips ensure a secure, stable connection and the 0.5 m length is suitable for typical internal routing within PC cases.

Suitable for

• Connecting 2.5" and 3.5" SATA hard drives and SSDs to motherboards or controller cards
• Internal connection of optical drives or flash-based SATA devices
• System builds and upgrades where a short internal SATA cable is required

Key specifications

• Cable type: SATA III
• Cable length: 0.5 m
• Connectors: SATA 7-pin to SATA 7-pin
• Maximum transfer rate: up to 6 Gb/s
• Product colour: Black, Blue

How to use

Align the 7-pin SATA connector with the device and motherboard SATA port, then press gently until the metal clip clicks into place to secure the connection. Route the 0.5 m cable inside the case to avoid interference with fans or other components and ensure a proper bend radius to prevent cable damage. To disconnect, press the metal clip and pull the connector straight out.

Recommendations

Use the cable for internal connections only; avoid bending the cable sharply or exposing it to excessive heat. For maximum performance, connect devices and host controllers that support SATA III to achieve speeds up to 6 Gb/s. If using with older SATA versions, expect lower transfer rates corresponding to those standards.