Power cord ProXtend PC-JC15-002, Swiss CEE 7/7 to IEC C15, 2 m

Power cord ProXtend PC-JC15-002 connects Swiss mains (CEE 7/7) to equipment with an IEC C15 inlet. With a 2 m flexible length and a straight CEE 7/7 plug, this cable is intended for devices that require the higher-temperature-rated C15 connector such as certain servers, UPS units and power supplies. The cord is designed for standard mains voltage environments and provides a stable connection between Swiss wall outlets and compatible IEC C15-equipped devices, allowing tidy routing and extended reach in technical rooms, offices and home setups.

Advantages

The cable combines a Swiss CEE 7/7 mains plug with an IEC C15 connector to support equipment that requires a higher temperature rating at the appliance inlet. The 2 m length balances reach and manageability, reducing the need for extension adapters while allowing flexible device placement. Constructed for reliable electrical contact and normal mains conditions, the cord supports straightforward installation and safe operation when used according to local regulations.

Suitable for

• Connecting servers and rack equipment with IEC C15 inlets to Swiss mains outlets
• Powering UPS units and power supplies that specify an IEC C15 connector
• Office and home electronics where a 2 m reach is required for neat cable routing
• Temporary or permanent installations in data centers and telecommunications rooms

Key specifications

• Plug type: Swiss CEE 7/7 (Schuko/Swiss hybrid)
• Appliance connector: IEC C15 (high-temperature inlet)
• Cable length: 2 m
• Designed for standard mains voltage use
• Sleeving and conductor sizing suitable for typical IT and office equipment power draws

How to use

Ensure the device you intend to connect specifies an IEC C15 inlet before use. Inspect the cable for visible damage and verify compatibility with local mains voltage and grounding requirements. Insert the IEC C15 connector firmly into the appliance inlet, then plug the CEE 7/7 mains plug into a properly grounded Swiss wall outlet. Arrange the cable to avoid sharp bends and pinch points, and do not overload the circuit beyond the device and installation ratings.

Recommendations

Use this cable only with equipment that requires an IEC C15 connector and in installations that comply with applicable electrical safety standards. Replace the cord if it shows signs of wear, damage or overheating. For permanent installations, allow sufficient slack and secure the cable to prevent strain on connectors.