Pipe cutter Rothenberger 70015 — cutting capacity 1/8 inch to 2 inch (3–50 mm)

Rothenberger Pipe Cutter 70015 is a compact handheld tool designed to cut pipes with a cutting range of approximately 1/8" to 2" (3–50 mm). The tool is intended for one-person operation and provides precise, clean cuts on metal and plastic tubing. Its compact profile and ergonomic shape allow access to confined spaces commonly encountered in plumbing, HVAC and general workshop tasks, producing pipe ends suitable for joining, flaring or threading.

Advantages

The cutter offers controlled rotation and a sharp cutting wheel that produces even cuts with minimal burrs. Its compact body makes it easier to use in tight locations compared with larger tools, while the adjustable clamping mechanism secures the pipe to reduce slippage during cutting. The simple, single-handed operation reduces setup time and the straightforward design minimizes maintenance needs.

Suitable for

• Cutting copper, aluminium and thin-walled steel tubing
• Trimming plastic pipes and conduit within the specified diameter range
• Plumbing repair and installation in confined or hard-to-reach areas
• HVAC tubing preparation and workshop tasks requiring accurate pipe ends

Key specifications

• Cutting capacity: approximately 3–50 mm (1/8"–2")
• Intended materials: metal and plastic tubing
• Operation: manual, single-person use
• Design: compact handheld form for access to confined spaces
• Cutting method: rotary cutting wheel with adjustable clamp

How to use

Place the pipe in the cutter’s jaws and tighten the clamping mechanism until the pipe is held firmly but not deformed. Rotate the tool around the pipe while gradually tightening the cutter wheel between rotations to maintain steady cutting pressure. Continue until the pipe is completely severed, then inspect the cut end and remove any small burrs with a deburring tool or fine file if required. Follow standard safety practices by wearing eye protection and securing the workpiece before cutting.

Recommendations

Use the cutter within its specified diameter range and avoid excessive force to prevent damaging the cutting wheel or deforming the pipe. Replace the cutting wheel if cuts become uneven or require excessive pressure. For thicker or hardened materials outside the specified range, use an appropriate cutting tool designed for those materials.