Photoconductor Unit Cyan Epson C13S051226 – 50,000-page yield, for colour printing (Cyan)

The Epson Photoconductor Unit Cyan C13S051226 is a replacement photoconductor designed to restore cyan image transfer and colour density in compatible Epson colour office printers. Supplied as a single cyan unit, it is intended for routine maintenance and consumable replacement to maintain print quality over extended print runs. The unit is specified with an estimated yield of 50,000 pages under standard test conditions and is manufactured to fit the relevant WorkForce series models.

Advantages

This cyan photoconductor unit provides a high estimated page yield, contributing to lower interruption frequency for colour maintenance cycles. It is manufactured to restore consistent cyan tone and sharpness, helping to maintain predictable colour output and reduce uneven fading or banding. The single-unit format simplifies replacement and handling during scheduled servicing.

Suitable for

• Office colour printing where cyan toner performance affects document and graphic quality
• Routine maintenance cycles for compatible Epson WorkForce series printers
• Environments requiring predictable cyan density across medium-to-high monthly page volumes

When it may not be suitable

This photoconductor unit is intended specifically for cyan colour printing and is not a complete toner cartridge; it must be used with a compatible toner supply and printer model. If your printer model is not listed among compatible WorkForce models, or if you require a multi-colour integrated assembly, this single-colour photoconductor may not meet your needs.

Key specifications

• Colour: Cyan
• Estimated page yield: 50,000 pages (standard test conditions)
• Form factor: Single photoconductor unit for replaceable maintenance
• Intended use: Office colour laser/LED printers (compatible models within specified series)
• Origin: Manufactured in China

How to use

Replace the old cyan photoconductor unit following the printer manufacturer’s maintenance instructions. Turn off the printer or follow the recommended service mode, open the designated access panel, remove the spent photoconductor carefully to avoid toner contact, and insert the new cyan photoconductor until it locks into place. After replacement, close panels and run any recommended alignment or calibration procedure to ensure correct cyan registration and colour balance.

What to consider before purchase

• Confirm printer compatibility with the photoconductor unit and the specific WorkForce series models supported
• Check whether you require only the photoconductor unit or a combined maintenance kit including toner
• Consider the estimated yield relative to your monthly volume and replacement interval

Recommendations

Store spare photoconductor units in a cool, dry place away from direct sunlight. Handle the unit by its edges and avoid touching the drum surface to prevent damage. Perform manufacturer-recommended calibration after installation to maintain accurate cyan reproduction.