Patchcord LANBERG PCF6-20CC-0150-B RJ45 Cat.6 1.5 m Blue, CCA U/UTP

LANBERG PCF6-20CC-0150-B is a Cat.6 RJ45 patchcord in blue with a length of 1.5 m. The cable uses 26 AWG copper-clad aluminium (CCA) conductors, an unshielded U/UTP topology and a PVC outer jacket. It supports frequencies up to 250 MHz and data rates up to 10 000 Mbit/s. Both ends are fitted with male RJ45 connectors and the cable has an outer diameter of 5.4 mm.

Advantages

The patchcord provides Cat.6 performance for typical LAN applications while using CCA conductors to reduce cost and weight. Its PVC jacket offers mechanical protection and flexibility for indoor installation. With standardized RJ45 male connectors on both ends, the cable ensures easy plug-and-play connection to switches, routers and network devices.

Suitable for

• Connecting switches and routers in home and small office networks
• Patch panels and wall sockets in structured cabling within buildings
• Desktop connections for PCs, printers and other networked devices

Key specifications

• Cable category: Cat.6
• Conductor material: Copper-clad aluminium (CCA)
• Wire size: 26 AWG
• Shielding: U/UTP (unshielded)
• Jacket material: PVC
• Frequency: up to 250 MHz
• Data transfer rate: up to 10 000 Mbit/s
• Connector type: RJ45 male – both ends
• Cable length: 1.5 m
• Outer diameter: 5.4 mm
• Colour: Blue

How to use

Plug one RJ45 male connector into the network port of your switch, router or workstation and the other end into the destination device or patch panel. Ensure connectors click into place to confirm a secure connection. Route the cable to avoid tight bends, sharp edges and sources of mechanical damage; maintain service loops where necessary for easier reconfiguration.

Recommendations

For optimal results, use this Cat.6 patchcord for typical Ethernet applications up to the supported frequency and data rate. Avoid outdoor exposure and direct contact with heat sources; use indoor-rated conduits or cable management when installing in ceilings or walls. If higher shielding or pure copper conductors are required for long runs or environments with strong electromagnetic interference, consider shielded or solid-copper alternatives.