LEDvance LED bulb set 2 pcs OSR64210DWBRT-2HFB 12V 19W automotive LED bulbs

Set of two LEDvance LED bulbs model OSR64210DWBRT-2HFB for 12V automotive systems. Each bulb has a rated power of 19W and is intended as a direct replacement where the specified base and electrical characteristics match. The twin pack provides two identical lamps for paired replacement in vehicles, reducing energy consumption and offering longer service life compared with conventional filament bulbs. These LED bulbs are suitable for a range of automotive lighting applications that accept the same physical fitting and voltage.

Advantages

These LEDvance bulbs combine higher energy efficiency with lower heat generation and extended operating life compared with traditional incandescent automotive lamps. The set of two ensures uniform light output when replacing paired lamps, helping to maintain consistent illumination and balanced appearance. Their solid-state design improves shock and vibration resistance important for vehicle use.

Suitable for

• Interior cabin lighting where the bulb base and 12V electrical system are compatible
• Exterior applications such as parking, side marker, or other low-voltage fixtures that accept the same fitting
• Paired lamp replacement to ensure even light output on both sides

Key specifications

• Voltage: 12V DC suitable for automotive electrical systems
• Power: 19W per bulb
• Pack quantity: 2 bulbs
• Solid-state LED construction for improved durability and vibration resistance
• Intended as a direct-fit replacement when base type and dimensions match the vehicle socket

How to use

Before installation, ensure the vehicle ignition is off and the relevant circuit is de-energized. Remove the existing bulb by accessing the fixture according to the vehicle manufacturer's instructions, then fit the LEDvance bulb into the socket, ensuring correct seating and polarity if required. After installation, verify proper operation by switching the circuit on and checking for correct illumination. Replace both bulbs in a paired location simultaneously to maintain uniform appearance and output.

Recommendations

Confirm compatibility with the vehicle's connector type and any on-board electronics. If the vehicle uses bulb monitoring or CAN-bus systems, additional resistors or adapters may be required to prevent error messages or hyper-flashing. Avoid installing in sealed high-temperature housings not rated for LED lamps unless the fixture allows adequate heat dissipation.