Laptop RAM Origin 8GB DDR4 3200MHz SODIMM 260-pin 1Rx8 Non‑ECC 1.2V

Origin 8GB DDR4 3200MHz SODIMM 260-pin 1Rx8 Non‑ECC 1.2V is a single-module laptop memory designed for systems that accept DDR4‑3200 SO‑DIMM modules. This 8 GB module uses a 260-pin SO‑DIMM form factor, operates at 1.2 V and features a 1Rx8 single-rank architecture with CAS latency 22. It is intended as an upgrade or replacement for compatible laptops and compact systems to increase available RAM and improve multitasking performance within the limits of the host platform.

Advantages

The module follows Origin Storage Matched Memory standards, manufactured from components sourced from established suppliers and tested for compatibility with OEM equipment. It provides a straightforward, cost‑effective upgrade path for DDR4‑compatible laptops and small form‑factor PCs, backed by lifetime warranty and technical support. Low operating voltage and standard SO‑DIMM pinout ensure wide compatibility and energy-efficient operation in supported devices.

Suitable for

• Upgrading memory in laptops that support 260-pin DDR4 SO‑DIMM 3200MHz modules
• Replacing a faulty or underperforming 8 GB DDR4 SO‑DIMM module
• Small form‑factor PCs and all‑in‑one systems with SO‑DIMM DDR4 slots
• Systems where a single‑rank (1Rx8) non‑ECC module is acceptable

Key specifications

• Capacity: 8 GB
• Memory type: DDR4
• Speed: 3200 MHz
• Form factor: 260‑pin SO‑DIMM
• Rank: 1Rx8 (single rank)
• CAS latency: 22
• Operating voltage: 1.2 V
• Weight: 0.1 kg

How to use

Power off the laptop or system and disconnect it from the mains. Access the memory compartment following the device manufacturer's service instructions. Align the 260‑pin SO‑DIMM edge connector with the slot and insert the module at the recommended angle until the side clips engage. Reassemble the device, reconnect power and boot the system. Verify that the BIOS/UEFI and operating system recognize the full 8 GB of installed memory and adjust any memory-related settings if required.

Recommendations

Before installing, confirm that the target system supports DDR4‑3200 SO‑DIMM modules and accepts single‑rank non‑ECC memory. For best results when expanding total memory, install modules in matching pairs where the motherboard supports dual‑channel operation. Handle the module by its edges and avoid contact with the gold contacts; follow anti‑static precautions to prevent damage.