Networking cable LOGON TCR55SS200B Cat5e F/UTP (FTP) Blue, 20 m, RJ-45–RJ-45

LOGON TCR55SS200B is a 20 m blue Cat5e F/UTP (FTP) networking cable with RJ-45 connectors on both ends, designed for Ethernet and LAN installations in homes and small offices. The cable uses four twisted pairs (4 x 2 AWG 26/7) with 100 Ohm impedance and foil shielding to reduce electromagnetic interference, ensuring stable data transmission at Cat5e performance levels. Shielded RJ-45 plugs with built-in boots and strain relief provide reliable mechanical protection and minimize kink and wear during repeated plugging and cable runs.

Advantages

The foil-shielded F/UTP (FTP) construction reduces crosstalk and external electromagnetic interference compared with unshielded cables, improving signal integrity in environments with multiple electrical devices. Shielded RJ-45 connectors and integrated boots with strain relief extend connector life and help maintain consistent contact quality. With Cat5e certification and 100 Ohm impedance, the cable supports standard gigabit Ethernet applications and plug-and-play installation without additional configuration.

Suitable for

• Wired Ethernet connections between switches, routers and PCs
• Patch panel to wall outlet or patch panel-to-switch cabling in small office networks
• Home networking where reduced electromagnetic interference is desired
• Temporary or permanent structured cabling runs up to 20 m

Key specifications

• Cable category: Cat5e F/UTP (FTP)
• Length: 20 m
• Conductor: 4 x 2 AWG 26/7, twisted pairs
• Impedance: 100 Ohm
• Connectors: RJ-45 shielded male — both ends
• Shielding: Foil over all pairs (F/UTP)
• Color: Blue
• Strain relief: Boot with kink protection

How to use

Connect one RJ-45 plug to your network device (router, switch or PC) and the other end to the destination device or patch panel. Ensure connectors are fully inserted until the latch clicks to secure contact. Route the cable without excessive bending; avoid sharp kinks and keep the cable away from high-power electrical lines where possible to maintain signal quality. No special software or drivers are required — the cable supports plug-and-play operation for compatible network equipment.

Recommendations

For best performance, maintain bending radii greater than the cable diameter, avoid tight loops and do not exceed the 20 m length for runs that require Cat5e performance. In environments with strong EMI sources, verify that both ends and the connected devices provide appropriate grounding for shielded cabling to ensure effective noise suppression.