Networking cable LOGON TCR55SS100O Cat5e SF/UTP (S-FTP) Orange 10 m RJ-45–RJ-45

LOGON TCR55SS100O is a 10 m Cat5e Ethernet patch cable with SF/UTP (S-FTP) shielding and RJ-45 connectors on both ends. The orange jacket provides easy visual identification in cabling environments. The cable is designed for balanced 100 Ohm data transmission and includes twisted pairs with a foil overall and individual pair drain/foil shielding to reduce electromagnetic interference in patch panels, switches, routers and workstation connections.

Advantages

The SF/UTP (S-FTP) construction offers improved protection against external noise compared with unshielded cables while maintaining Cat5e performance for up to 100 Mbps or gigabit-capable short-range links depending on connected equipment. The cable uses 26/7 stranded conductors for a flexible yet reliable connection, and molded boots with strain relief and kink protection increase connector longevity in repeated handling or in tight routing scenarios. The bright orange jacket simplifies identification in structured cabling systems and aids organised cable management.

Suitable for

• Patching between network switches, patch panels and routers in office racks
• Connecting desktop workstations and VoIP phones to wall outlets
• Environments where extra shielding is needed to reduce EMI from nearby equipment
• Temporary or permanent installations requiring clearly marked cable runs

Key specifications

• Category: Cat5e
• Shielding type: SF/UTP (S-FTP) — foil overall with individual pair shielding
• Conductor: 4 x 2 AWG 26/7 twisted pairs (stranded)
• Characteristic impedance: 100 Ohm
• Connectors: RJ-45 Male — RJ-45 Male
• Length: 10 m
• Outer jacket colour: Orange
• Molded boot with strain relief and kink protection
• Certification level: Cat5e (3 P Cat5e certified)

How to use

Connect one RJ-45 end of the LOGON Cat5e SF/UTP cable to the network device port (switch, router or patch panel) and the other end to the target device (workstation, VoIP phone or another network port). Ensure connectors are fully seated until the latch clicks. Route the cable to avoid sharp bends and sources of strong electromagnetic interference; maintain bend radius consistent with manufacturer guidance. For rack or patch-panel installations, use cable management arms or ties to secure the cable and reduce mechanical strain on connectors.

Recommendations

Use this SF/UTP Cat5e cable when additional shielding is desirable to minimise interference from nearby power supplies, fluorescent lighting or motors. Avoid running alongside high-voltage power cables when possible. For permanent installations, test link performance with appropriate network testers after termination to verify continuity, pair integrity and shielding effectiveness.