Networking cable LOGON TCF66F100O Cat6a F/UTP (FTP) RJ-45 — 10 m, orange

The LOGON TCF66F100O Cat6a F/UTP (FTP) RJ-45 — 10 m, orange is a shielded network patch cable designed for high-speed Ethernet and structured cabling installations. With a 10 m length, foil (F/UTP) shielding and two shielded RJ-45 connectors, this cable meets Cat6a performance expectations and is suitable for connecting LAN devices, switches, routers and patch panels in home and office environments. The cable construction uses four twisted pairs (26 AWG, 7-strand) with 100 ohm characteristic impedance and a PVC sheath for basic mechanical protection.

Advantages

Foil shielding reduces electromagnetic interference and crosstalk compared with unshielded cables, improving signal integrity in areas with multiple electronic devices. Dual RJ-45 shielded plugs ensure reliable connector grounding and stable data transmission. The 10 m length provides flexibility in typical room-to-room or rack-to-desk connections while the Cat6a specification supports higher bandwidth and Gigabit or 10 Gigabit Ethernet links within the supported channel limits.

Suitable for

• Connecting switches, routers and patch panels in small office and home networks
• Structured cabling runs requiring Cat6a performance and improved shielding
• Short to medium length Ethernet links up to 10 m between equipment

Key specifications

• Category: Cat6a (F/UTP / FTP)
• Length: 10 m
• Conductor: 4 x 2, 26 AWG, 7-strand twisted pairs
• Impedance: 100 Ω
• Connectors: RJ-45 shielded male — both ends
• Sheath material: PVC
• Color: orange
• Installation: plug-and-play

How to use

Ensure devices are powered off or follow hot-swap procedures recommended by your equipment vendor. Plug one shielded RJ-45 connector into the network port of your switch, router or device, and the other into the corresponding port on the patch panel or endpoint. Route the cable to avoid tight bends and sources of strong electromagnetic interference; secure with cable ties or management accessories as needed. The cable is ready for immediate use without additional termination.

Recommendations

For optimal performance, avoid running the cable in parallel with heavy power lines for long distances and maintain bend radii greater than four times the cable diameter. Use shielded connectors and properly grounded infrastructure when deploying F/UTP cables to ensure effective shielding and minimize noise in high-density environments.