Networking cable LOGON SSTP Cat6a RJ-45 RJ-45 5 m Red

The LOGON SSTP Cat6a RJ-45 to RJ-45 networking cable, 5 m in red, is built for high-speed wired connections and compatibility with standard Ethernet equipment. It uses Cat6a construction to support up to 10 Gbps data rates and features shielded RJ45 connectors on both ends for stable signal transmission in installations that require reduced interference.

Advantages

This SSTP Cat6a cable includes foil and full braid shielding around the twisted pairs and shielded RJ45 plugs to minimise electromagnetic interference. The cable contains 4 pairs (4 x 2) of AWG 26/7 twisted conductors with 100 Ohm characteristic impedance and a 1:1 EIA/TIA 568B pinout for straightforward, standard wiring. Flexible boots with kink protection and strain relief improve connector durability and reduce the risk of damage at the plug ends.

Suitable for

• 10 Gigabit Ethernet over short to medium distances
• Office and home network connections between switches, routers, and computers
• Environments where additional shielding is needed to reduce EMI/RFI
• Structured cabling following EIA/TIA 568B wiring

Key specifications

• Length: 5 m
• Cable category: Cat6a (SSTP)
• Conductor configuration: 4 x 2 x AWG 26/7, twisted pair
• Impedance: 100 Ohm
• Connectors: 2 × shielded RJ45 (male)
• Wiring: 1:1 — EIA/TIA 568B
• Colour: Red

How to use

Connect one shielded RJ45 plug to your network device (switch, router or network interface) and the other end to the corresponding device. Ensure both devices support the Cabling category for optimal performance. Route the cable avoiding sharp bends; use the boot with kink protection to prevent damage near the connectors. No special termination is required because the cable is pre-terminated with RJ45 plugs.

Recommendations

For best 10 Gbps performance, use within recommended maximum distances for Cat6a and avoid running the cable parallel to high-voltage power lines. In noisy electromagnetic environments, verify that both connected devices and patch panels provide proper shielding continuity.