Networking cable LOGON SSTP Cat6a RJ-45 RJ-45 3 m Black

The LOGON SSTP Cat6a RJ-45 to RJ-45 networking cable (3 m, black) is a shielded twisted-pair cable designed for high-speed wired Ethernet connections. It uses SSTP construction with pairs protected by foil and an overall braided shield, and terminated with two shielded RJ45 male connectors wired 1:1 (EIA/TIA 568B). The cable supports Cat6a performance suitable for 10 Gbps network segments and is intended for use in professional and home network installations.

Advantages

The SSTP Cat6a design (4 x 2 x AWG 26/7, twisted pair, 100 Ohm) reduces electromagnetic interference and crosstalk thanks to foil and full braid shielding. Shielded RJ45 connectors with boots that include kink protection and strain relief improve connector durability and ensure reliable terminations. The 3 m length provides flexibility for connecting devices within racks, workstations, or home offices while maintaining Cat6a signal integrity.

Suitable for

• Connecting switches, routers and servers in LANs
• High-speed links up to 10 Gbps where Cat6a is required
• Shielded installations to reduce EMI in noisy environments
• Workstations, patch panels and professional network equipment

Key specifications

• Cable type: SSTP (foil + full braid)
• Conductor: 4 x 2 x AWG 26/7, twisted pair
• Impedance: 100 Ohm
• Connectors: 2 x shielded RJ45 male (1:1 EIA/TIA 568B)
• Length: 3 m
• Colour: Black
• Brand / MPN / EAN: LOGON PROFESSIONAL / TCR6ASS030BL / 5420016811639

How to use

Plug each shielded RJ45 connector into the corresponding Ethernet port on your devices (for example switch, router or network card). Ensure the connectors are fully seated until the latch clicks and avoid sharp bends near the boots; the built-in kink protection and strain relief help maintain a stable connection. Use the cable in standard 1:1 wiring environments (EIA/TIA 568B) and conform to your network equipment grounding practices when using shielded cabling.

Recommendations

For best performance, avoid running the cable parallel and close to power lines or large electrical equipment. In shielded installations, connect cable shields to chassis or system ground at least at one end according to local grounding standards to reduce EMI.