Networking Cable LogiLink 30m RJ-45 Cat6 S/FTP Grey

The LogiLink 30m RJ-45 Cat6 S/FTP Grey networking cable supports data rates up to 1 Gbit/s and is designed for reliable wired connections between network devices. It features RJ-45 connectors on both ends, S/FTP shielding (braided drain wire with foil around each twisted pair) to reduce electromagnetic interference and crosstalk, and a 30 m length that provides installation flexibility in homes and offices. The cable is manufactured to industry standards and European regulations and is available in a grey finish.

Advantages

This Cat6 S/FTP cable offers high-speed Gigabit performance and enhanced protection from interference thanks to foil-wrapped twisted pairs plus an overall braid. Molded RJ-45 ends with strain relief and a snagless boot design improve connector durability and simplify installation. The 30 m length provides extended reach while maintaining flexibility for routing and cable management.

Suitable for

• Wired connections between PCs, switches and routers
• Home networks and small office LANs
• Areas with elevated electromagnetic interference where shielded cable is required
• Structured cabling runs requiring a 30 m patch lead

Key specifications

• Length: 30 m
• Standard: Cat6 (10/100/1000Base-T(X))
• Shielding: S/FTP (overall braid + foil on each pair)
• Connectors: RJ-45 to RJ-45, molded ends with strain relief and snagless boot
• Colour: Grey
• Data rate: up to 1000 Mbit/s

How to use

Connect one RJ-45 connector to your network device (PC, switch, router or modem) and the other to the corresponding port on the opposite device. Ensure connectors click into place to confirm a secure connection. Route the cable to avoid sharp bends, pinching or tight cable ties; allow slack near equipment to prevent strain on the connectors. For long installations, test the link with a network tester to verify continuity and performance.

Recommendations

For optimum performance, keep the cable away from strong sources of electrical noise (large motors, fluorescent ballast, power busways) and avoid running it in parallel with high-voltage power lines. Use shielded patch panels and properly terminate shields where required in structured installations.