Networking Cable LogiLink 30m RJ-45 Cat5e UTP Grey

The LogiLink 30m RJ-45 Cat5e UTP Grey networking cable provides a 30-metre connection for Ethernet networks using RJ-45 connectors on both ends. Constructed to meet Cat5e performance, the cable supports typical home and office data transmission requirements with copper-plated contacts and a U/UTP structure. The neutral grey jacket conceals the conductors and connectors while allowing straightforward routing across rooms or between network hardware.

Advantages

This Cat5e cable offers a long 30 m reach suitable for connecting devices that are separated by moderate distances without adding intermediate equipment. The RJ-45 connectors on both ends ensure compatibility with common routers, switches, network interface cards and patch panels. Copper-plated contacts provide consistent electrical contact and signal transfer. The U/UTP construction is intended for environments where individual pair shielding is not required, reducing cost and maintaining flexibility for standard Ethernet installations.

Suitable for

• Wired Ethernet connections in homes and small offices
• Connecting routers, switches, network printers and PCs
• Patch cable runs between network equipment and wall outlets
• Temporary or semi-permanent cabling where a 30 m length is needed

Key specifications

• Cable length: 30 m
• Cable category: Cat5e
• Shielding type: U/UTP (unshielded pairs within an overall unshielded jacket)
• Connectors: RJ-45 to RJ-45
• Contact plating: copper-plated contacts
• Colour: Grey

How to use

Plug one RJ-45 connector into the Ethernet port of your router, switch or modem and insert the other end into the Ethernet port of the destination device such as a PC, printer or network-attached storage. Route the cable along walls, under desks or through cable management channels to minimise strain and avoid sharp bends. Ensure connectors are fully inserted until they click to secure a stable physical and electrical connection.

Recommendations

Do not run the cable parallel to high-voltage power lines for extended distances to reduce possible electromagnetic interference. Avoid tight bends and excessive tension that can damage the internal conductors. For environments requiring improved shielding or higher bandwidth, consider using higher category or shielded cable types.