Networking Cable LogiLink 1m RJ-45 Cat6 S/FTP Green

LogiLink 1m RJ-45 Cat6 S/FTP green patch cable is a shielded network cable designed for reliable high-speed data transmission in home and office environments. The cable uses S/FTP (screened foil twisted pair) construction with PIMF shielding, bare copper conductors and RJ45 connectors on both ends. The LSZH jacket reduces smoke and toxic gas emission in case of fire and the cable complies with ISO/IEC 11801, EN50288 and TIA/EIA 568-B.2-1 standards.

Advantages

The Cat6 S/FTP design provides improved protection against electromagnetic interference and crosstalk compared with unshielded cables, supporting stable and consistent signal quality. Bare copper conductors and AWG 27/7 stranded construction ensure good conductivity and flexibility for installation. The LSZH jacket offers low smoke and zero halogen characteristics for safer indoor use, while the 1.00 m length and standard RJ45 connectors make the cable suitable for typical patching and short-distance connections.

Suitable for

• Patching between network switches and patch panels
• Connecting routers, modems and desktop computers
• Short horizontal runs in office or home network setups
• Environments where reduced smoke and halogen emissions are required

Key specifications

• Category: Cat6
• Shielding: S/FTP (PIMF)
• Conductor: bare copper, AWG 27/7
• Connector: RJ-45 to RJ-45
• Length: 1.00 m
• Jacket: LSZH (low smoke zero halogen)
• Weight: 40 g
• Standards: ISO/IEC 11801, EN50288, TIA/EIA 568-B.2-1
• Colour: Green

How to use

Plug one RJ45 connector into the network device (switch, router, patch panel or computer) and the other connector into the corresponding port on the second device. Ensure connectors are fully inserted until the latch clicks. Route the cable without sharp bends and avoid running parallel to power cables to minimise interference. For best performance, use short patch lengths for local connections and keep slack organised in cable management panels.

Recommendations

For stable Gigabit connections, verify both connected devices support the required speeds and use shielded ports or grounded equipment when deploying S/FTP cables to maintain the shielding effectiveness.