Networking Cable LogiLink 1m Cat.6A RJ-45 S/FTP Orange

Patch Cable Cat.6A 10G S/FTP PIMF PrimeLine red 1,00m LogiLink® (LogiLink 1m Cat.6A RJ-45 S/FTP Orange) is a 1.0 m network patch cable with RJ-45 connectors, designed to meet Cat6A class requirements for 10 Gbps data transmission. The cable uses S/FTP (shielded foiled twisted pair with overall braid) PIMF construction with bare copper conductors and an LSZH (low smoke zero halogen) outer jacket. It complies with ISO/IEC 11801, EN50288 and TIA/EIA 568-C.2 standards and weighs approximately 40 g.

Advantages

The S/FTP PIMF design provides improved protection against electromagnetic interference and crosstalk, supporting stable high-speed connections up to Cat6A performance. Bare copper conductors ensure reliable signal transmission while the LSZH jacket reduces hazardous smoke and halogen release in case of fire. Compact 1 m length is suitable for short runs between devices and patch panels, and the standardized RJ-45 terminations allow broad compatibility with network equipment.

Suitable for

• Connecting switches, routers and patch panels in office and data center environments
• High-speed Ethernet links up to 10 Gbps for server and workstation connections
• Short cable runs within racks, desks or wall outlets

Key specifications

• Cable type: Cat.6A S/FTP (PIMF)
• Length: 1.00 m
• Connector: RJ-45 to RJ-45
• Conductor: bare copper, AWG 26/7
• Jacket: LSZH (low smoke zero halogen)
• Standards: ISO/IEC 11801, EN50288, TIA/EIA 568-C.2
• Weight: 40 g
• Colour: Orange (market listing: red/orange)

How to use

Plug the RJ-45 connector into the network port of your device and the other end into a switch, router or patch panel. Ensure connectors are fully inserted until they click to establish a secure connection. For optimal performance, avoid tight bends and prevent the cable from being pinched or stretched; maintain the manufacturer's minimum bend radius for Cat6A cables when routing.

Recommendations

Use this 1 m Cat6A S/FTP patch cable for short high-speed links where shielding and low-smoke jacket properties are required. Avoid running the cable parallel and close to high-power electrical lines to minimize interference. Inspect connectors for damage before installation and replace the cable if the jacket or plug is compromised.