Networking cable GEMBIRD Cat6a RJ-45 to RJ-45 S/FTP 10 m LSZH, solid copper, grey

The Gembird PP6A-LSZHCU-10M RJ-45 Cat6a 10m Grey is a networking cable engineered for reliable wired data connections over a moderate distance. This Cat6a cable has a 10 metre length and is constructed with S/FTP shielding to reduce electromagnetic interference and crosstalk. Both ends are fitted with gold-plated RJ-45 connectors for secure contact and consistent signal transfer. The grey jacket provides a neutral appearance suitable for home, office, and installations where cabling should remain unobtrusive.

Advantages

S/FTP shielding enhances signal integrity by combining overall foil protection with individually screened pairs, which helps maintain throughput in environments with nearby electrical equipment. Gold-plated RJ-45 connectors improve corrosion resistance and contact reliability for repeated insertions. The 10 m length covers typical runs between network devices without requiring splices or additional patch cords, while the Cat6a specification supports higher frequency operation compared with older cable classes.

Suitable for

Key specifications

How to use

Route the cable between network devices ensuring bends are gentle and the minimum bend radius recommended by the installer is observed. Insert each RJ-45 connector firmly into the corresponding port until the latch clicks to secure the connection. Avoid placing the cable parallel and close to mains power cables for extended lengths to reduce noise pick-up; if crossing power lines is unavoidable, do so at right angles. Test the link with a network tester or by verifying connectivity on connected devices after installation.

Recommendations

For best performance, keep the cable away from strong electromagnetic sources and avoid sharp bends or tight pulls during installation. Use the 10 m length as a single continuous run to preserve shielding effectiveness and connector integrity.