Network interface card LANBERG NC-0100-01 USB 10 Gbit/s, hot-swap, cable 0.15 m, black

The Interface Card Lanberg NC-0100-01 is a compact 10 Gbit/s network interface designed for systems requiring high-speed connectivity in a small form factor. Weighing approximately 20 g and finished in black, the card provides a short 0.15 m cable for direct connection and is supplied as a single unit. Its compact dimensions and light weight make it suitable for installations with limited space or where minimal added mass is important.

Advantages

The card delivers a sustained data transfer rate of 10 Gbit/s, supporting high-bandwidth applications and reducing latency in data exchange. Its compact physical profile and low weight simplify installation and cable management in confined chassis or densely packed racks. The short integrated cable reduces excess wiring while offering sufficient reach for adjacent ports or internal connections. The black finish provides a neutral appearance that integrates with most hardware environments.

Suitable for

• Upgrading desktop or server systems to 10 Gbit/s network speeds
• Compact or space-constrained workstation and NAS installations
• Environments requiring low-profile cards for dense hardware layouts
• Connections where a short cable run (0.15 m) is sufficient

Key specifications

• Data transfer rate: 10 Gbit/s
• Weight: 0.02 kg
• Color: Black
• Integrated cable length: 0.15 m
• Unit type: single piece

How to use

Install the Interface Card Lanberg NC-0100-01 into a compatible expansion slot or designated connector following the host system manufacturer's instructions. Ensure the system is powered down and grounded before insertion. Route the short 0.15 m cable to the corresponding network port or internal connector, secure any retaining clips if present, and restore power. After system startup, verify link status and configure network settings in the operating system or network controller utility to enable 10 Gbit/s operation as required.

Recommendations

For optimal performance, use the card in systems and with cabling rated for 10 Gbit/s operation. Maintain adequate airflow around the card and adjacent components to prevent thermal throttling. When the installation requires longer cable runs, use externally routed cabling or alternate modules designed for that distance rather than extending the built-in short cable.