Network Cable ROLINE S/FTP (PiMF) Patch Cord RJ-45 Cat.6 10 m Grey

Network Cable ROLINE S/FTP (PiMF) Patch Cord RJ-45 Cat.6 10 m Grey is a prepared patch cable for networking connections between devices. It uses a 4-pair stranded copper conductor with complete braid shielding and pairs wrapped in aluminium-clad polyester foil. The cable is fitted with screened RJ-45 connectors on both ends and has contact wiring 1:1 in accordance with the EIA/TIA 568 standard.

Advantages

The S/FTP (PiMF) design provides strong protection against electromagnetic interference and crosstalk. Gold-plated contacts in high-quality plugs ensure reliable signal transmission and corrosion resistance. The moulded kink protection increases connector durability while the flexible cable construction allows routing in confined spaces and narrow bends. Cat.6 specification supports higher data rates for modern network environments.

Suitable for

• Wired Ethernet connections between computers, switches and routers
• Office and data centre patching within structured cabling
• High-speed LAN applications requiring Cat.6 performance
• Installations needing improved EMI protection (S/FTP shielded cables)

Key specifications

• Length: 10 m
• Connectors: RJ-45 to RJ-45, screened
• Cable category: Cat.6
• Conductor: 4-pair stranded copper
• Shielding: complete braid + aluminium-clad polyester foil around pairs (S/FTP, PiMF)
• Contact wiring: 1:1 (EIA/TIA 568)
• Contacts: gold plated
• Colour: Grey

How to use

Connect one RJ-45 connector to the network port of your device and the other end to a switch, router or patch panel. Ensure connectors are fully inserted until they click to secure the connection. Route the cable avoiding sharp edges and excessive tension; the moulded kink protection near the plugs reduces risk of damage at bending points. For best performance, keep the cable separate from power lines and strong EMI sources.

Recommendations

Use this Cat.6 S/FTP patch cord for short- to medium-length Ethernet links within racks, wall outlets and between network equipment where reduced interference and Cat.6 performance are required. Do not exceed recommended bend radius and avoid repeated heavy flexing to maintain long-term signal integrity.