Network cable LOGON UTP Cat.5e 25 m, unshielded twisted pair, RJ-45–RJ-45, ivory

LOGON UTP Cat.5e 25 m network cable is an unshielded twisted pair patch cable with RJ-45 connectors on both ends, designed for reliable copper Ethernet connections up to the Cat5e standard. With a 25-metre ivory jacket and 4 pairs of 26 AWG stranded conductors, the cable supports common wired network links between switches, routers, PCs and wall outlets while maintaining consistent impedance and signal integrity for typical office and home installations.

Advantages

The unshielded twisted pair construction provides balanced transmission and reduced electromagnetic interference for most indoor networking environments. Stranded 26/7 conductors offer flexibility for routing and frequent handling, while RJ-45 male connectors with boots and kink protection ensure secure plug-in connections and strain relief. The 25 m length covers longer patch runs without additional couplers and the ivory jacket blends into light-coloured interiors.

Suitable for

• Connecting desktop PCs, laptops and network switches in offices and homes
• Patching between wall outlets and network equipment
• Temporary or semi-permanent cabling where flexibility is required

Key specifications

• Cable type: UTP (Unshielded Twisted Pair)
• Category: Cat.5e, supports up to 100 MHz
• Length: 25 m
• Conductor: 4 pairs, 26 AWG stranded (26/7)
• Impedance: 100 Ohm
• Connectors: RJ-45 male to RJ-45 male with boots and strain relief
• Color: Ivory (light beige)

How to use

Plug one RJ-45 connector into the network port of a device such as a switch, router or PC, and plug the other end into the corresponding port on the destination device or wall outlet. Ensure connectors are fully inserted until the latch clicks. Route the cable to avoid sharp bends and prevent kinks; the boots provide additional protection at the connector ends. For wall runs or permanent installations, secure the cable with appropriate clips or cable management accessories without compressing the jacket.

Recommendations

Use this Cat.5e UTP cable for Ethernet connections up to 100 Mbps or 1 Gbps where Cat5e performance is sufficient. Avoid running the cable parallel to high-voltage power lines to reduce potential interference. For outdoor, direct-burial or shielded-environment requirements, select a cable type specifically rated for those conditions.