Network cable LOGON Cat6 UTP 15 m Red — RJ-45 to RJ-45, unshielded

LOGON Cat6 UTP 15 m Red networking cable with RJ-45 to RJ-45 connectors is designed for straightforward Gigabit Ethernet connections across a 15-metre span. The unshielded twisted pair (UTP) construction uses four pairs of 26 AWG (26/7) wires with 100 Ohm characteristic impedance and supports frequencies up to 250 MHz. The cable comes in a red jacket and features molded boots with kink protection and strain relief to reduce connector stress during installation and use.

Advantages

The cable complies with Cat6 standards and is 3P Category 6 certified, providing reliable transmission for gigabit networks over the specified 15 m length. Its 26/7 conductor construction balances flexibility and signal integrity while the UTP design keeps the cable lightweight and easy to route. Molded RJ-45 connectors on both ends and the integrated boot with kink protection simplify repetitive patching and help prevent accidental cable damage at the connector interface.

Suitable for

• Connecting computers, switches and routers in home or small office networks
• Patch panel to wall socket or patch panel to switch links within a 15 m run
• Temporary network setups and equipment rearrangements

Key specifications

• Length: 15 m
• Cable type: Cat6 UTP (unshielded twisted pair)
• Conductor: 4 × 2, 26 AWG (26/7)
• Characteristic impedance: 100 Ohm
• Frequency rating: up to 250 MHz
• Connectors: RJ-45 male to RJ-45 male
• Boot: molded with kink protection and strain relief; spot length marking on boot
• Connection wiring: 1:1 (straight-through)
• Color: red

How to use

Verify that both network devices are powered off or can tolerate hot-plugging, then insert each RJ-45 connector into the Ethernet ports of the devices until the latch clicks. For patching through patch panels or wall outlets, ensure connectors are fully seated and routed to avoid sharp bends or crushing. The molded boot with strain relief reduces stress at the connector; avoid excessive pulling on the cable jacket when disconnecting. Test the link with network diagnostic tools to confirm Gigabit connectivity and correct wiring.

Recommendations

Use this LOGON Cat6 UTP cable for short to medium runs up to 15 m where a clear, visible color coding is useful. Keep the cable away from strong EMI sources where possible; although UTP is suitable for most home and office environments, avoid running it in parallel with high-voltage power lines to minimize interference. Replace the cable if connectors or the jacket show visible damage.