Network cable LANBERG PCF6-20CC-0200-S Cat6 U/UTP RJ-45–RJ-45 2 m Grey 10 Gbit/s

LANBERG PCF6-20CC-0200-S is a 2 m Cat6 U/UTP (UTP) Ethernet patch cable with RJ-45 connectors on both ends. Designed for data links between switches, routers, patch panels and workstations, this grey cable supports data rates up to 10 Gbit/s and is suitable for rack, office and home network patching where a short, reliable connection is needed.

Advantages

The cable provides Category 6 performance in an unshielded U/UTP (UTP) design, offering support for up to 10 Gbit/s over short runs. With RJ-45 male connectors on both ends and a compact 2 m length, it simplifies neat cable management in racks and workspaces while maintaining full compatibility with standard Ethernet ports.

Suitable for

Key specifications

How to use

Plug each RJ-45 connector into the corresponding Ethernet port on your network devices (switch, router, patch panel or NIC). Ensure connectors are fully inserted until the latch clicks to secure the connection. Route the cable to avoid sharp bends and mechanical stress; use cable management accessories in racks and under desks to keep the run tidy and reduce strain.

Recommendations

For optimal 10 Gbit/s performance, keep cable runs within recommended Cat6 distances for high-speed links and avoid running alongside strong electrical noise sources. Use in typical indoor environments; not intended for outdoor or direct burial use.