Network Cable Digitus CAT 6A U/UTP twisted pair patch cord raw 100m Grey

The Digitus CAT 6A U/UTP twisted pair patch cord raw 100m in grey is a bulk network cable designed for producing custom patch cords and permanent link installations. It meets contemporary standards for high-frequency data transmission up to 500 MHz and is manufactured from copper conductors to ensure reliable signal quality. The cable is PoE+ ready and conforms to industry cabling norms to support Class EA installations.

Advantages

This raw Cat 6A U/UTP cable is suitable for direct assembly with RJ45 connectors to produce patch cords and supports Class EA performance (500 MHz). It is manufactured and tested according to ISO/IEC 11801 and DIN EN 50173 specifications, ensuring compatibility with ISO & EN channel requirements. Copper conductors provide stable electrical characteristics and the U/UTP construction minimises external electromagnetic interference for reliable network performance.

Suitable for

• Producing custom RJ45 patch cords
• Permanent link and structured cabling for Class EA (Cat6A) networks
• High-speed Ethernet and PoE+ installations
• Office and data center horizontal cabling runs

Key specifications

• Cable type: CAT 6A U/UTP twisted pair
• Length: 100 m
• Conductor material: Copper (Cu)
• Frequency rating: up to 500 MHz (Class EA)
• Connectors: no connectors pre-assembled (raw cable for connector assembly)
• Colour: Grey
• Standards: ANSI/TIA-568-C; ISO/IEC 11801 2nd Ed.; EN 50173-1; EN 50288-11-1
• PoE support: PoE+ ready

How to use

Cut required cable length from the 100 m bulk reel and strip the outer jacket to expose the four twisted pairs. Arrange and terminate the pairs according to the chosen wiring scheme (T568A or T568B) and crimp RJ45 connectors using appropriate tools and tester. Test each assembled patch cord or permanent link with a suitable cable tester to verify continuity, pair integrity, and category performance.

Recommendations

Store the cable on a reel and avoid tight bends or kinks that exceed the manufacturer’s minimum bend radius. Use compatible RJ45 connectors rated for Cat6A and perform post-termination testing to ensure compliance with Class EA channel specifications.