Mini SAS cable FANTEC SRC SFF-8643 to SFF-8087 0.7 m

FANTEC SRC Mini SAS cable with SFF-8643 to SFF-8087 connectors, 0.7 m long, provides a compact, reliable connection between SAS host adapters, controllers, backplanes and storage enclosures. The cable is intended for high-density server and workstation environments where space is limited and robust internal-to-internal or external-to-internal links are required. Its short length minimizes signal attenuation and cable clutter in rack-mounted systems and equipment upgrades.

Advantages

The cable supports a direct connection between SFF-8643 and SFF-8087 interfaces, offering consistent signal integrity for SAS data paths. Its compact 0.7 m length reduces excess cabling while allowing flexible routing inside chassis and racks. The design is suitable for dense storage configurations and minimizes interference and mechanical strain on connectors during installation and maintenance.

Suitable for

• Connecting SAS host adapters or controllers to backplanes
• Linking external SFF-8643 ports to internal SFF-8087 connectors
• Data center rack cabling and server upgrades
• High-density storage enclosures and workstation setups

Key specifications

• Connector types: SFF-8643 (one end) to SFF-8087 (other end)
• Cable length: 0.7 m
• Interface: Mini SAS (SAS protocol compatible)
• Usage: Internal-to-internal or external-to-internal connections in server/storage systems
• Construction: Compact, shielded design for reduced interference

How to use

Install the cable by aligning the SFF-8643 and SFF-8087 connectors with the corresponding ports on the host adapter, controller, or backplane and press until the connectors seat securely. Route the cable to avoid sharp bends and prevent strain on the connector housings; secure with cable ties or guides as needed. Verify link status on connected devices after installation and perform any required configuration on the host adapter or storage controller.

Recommendations

Use this 0.7 m Mini SAS cable where short, direct connections are required inside racks or chassis. Avoid excessive bending and exposure to high temperatures; maintain clear access to connectors for servicing and ensure compatibility with the SAS devices and ports in your system.