DIMM 8 GB DDR3-1866 (2x 4 GB) Dual-Kit, Arbeitsspeicher F3-14900CL9D-8GBSR, Sniper, Lite Retail

The G.Skill DDR3 8GB 1866MHz memory module is a dual-channel kit composed of 2 x 4GB DDR3 DIMMs designed for desktop PCs and compatible server platforms. Operating at an effective clock speed of 1866 MHz with a CAS latency of 9, this 240-pin module delivers faster memory access compared with lower-frequency DDR3 modules. Rated to run at a standard DDR3 voltage of 1.5 V, the kit provides 8 GB total system memory capacity and supports multitasking and memory-intensive applications in systems that accept DDR3 240-pin modules.

Advantages

This G.Skill 2 x 4GB kit offers improved bandwidth and responsiveness over lower-speed DDR3 modules thanks to its 1866 MHz operating frequency and CL9 timing. The dual-module configuration enables dual-channel operation when installed in matching motherboard slots, increasing data throughput. The module's 240-pin DIMM form factor ensures compatibility with a wide range of desktop motherboards and server boards that support DDR3 memory at the specified voltage and speed.

Suitable for

• Upgrading desktop PCs to increase total RAM to 8 GB
• Building or refurbishing systems that require DDR3 240-pin DIMMs
• Everyday multitasking, office applications and light content creation
• Dual-channel memory configurations on compatible motherboards

Key specifications

• Total capacity: 8 GB (2 x 4 GB)
• Memory type: DDR3
• Effective clock speed: 1866 MHz
• CAS latency: 9
• Form factor: 240-pin DIMM
• Operating voltage: 1.5 V

How to use

Power off the computer and disconnect it from the mains before installing memory. Open the case and locate the DIMM slots on the motherboard. Consult the motherboard manual to identify the correct slots for dual-channel installation, then align the notch on each 240-pin DIMM with the slot key and press firmly until the module clicks into place and the retention clips engage. After installation, reconnect power and boot the system. Verify that the BIOS/UEFI recognizes the full 8 GB capacity and the intended memory frequency; adjust memory settings in BIOS/UEFI if required and supported by the motherboard.

Recommendations

Install the modules as a matched pair in the motherboard slots recommended for dual-channel operation to achieve optimal bandwidth. Use the motherboard manual to confirm supported memory frequencies and voltage; if system stability issues occur at the rated 1866 MHz, set the memory to a lower supported speed in BIOS/UEFI. Avoid mixing modules with different speeds, voltages or timings to prevent incompatibility or reduced performance.