LANBERG network junction box PLC-6SL1-S, Cat6 S/FTP (S-STP), silver, 82×35×23 mm

LANBERG network junction box PLC-6SL1-S is a compact protective enclosure designed for Cat6 S/FTP (also known as S-STP) shielded twisted-pair cabling. Finished in silver and sized 82×35×23 mm, this junction box is intended for indoor installations to house terminations, splice points and an LSA-style Category 6 shielded connector. It accommodates both T568A and T568B wiring schemes and provides mechanical protection and electromagnetic shielding continuity for shielded Cat6 links.

Advantages

The LANBERG PLC-6SL1-S offers a small footprint suitable for tight installation spaces while maintaining shield continuity for S/FTP cabling. Its silver finish is neutral for visible installations, and the internal layout supports LSA-style Category 6 FTP connectors to ensure reliable signal transmission. The enclosure protects cable terminations from mechanical damage and dust, and its dimensions enable discreet mounting in many indoor locations.

Suitable for

• Indoor shielded Cat6 cable terminations and splices
• Small junctions behind wall plates, furniture, or equipment racks
• Installations requiring T568A or T568B wiring
• Environments where maintaining shielding continuity is needed

Key specifications

• Cable category: Cat6 (S/FTP, S-STP shielding)
• Internal connector type: LSA-style Category 6 FTP compatible
• Supported wiring standards: T568A and T568B
• Material/finish: silver coloured enclosure
• Dimensions: 82 × 35 × 23 mm
• Intended use: indoor junction box for terminations and splices

How to use

Prepare the shielded Cat6 cable by stripping the outer jacket and folding back the drain wire or braid to expose the individual pairs. Follow either T568A or T568B wiring scheme when punching down pairs into the LSA-style Category 6 FTP connector inside the junction box. Ensure the braided shield and drain conductor are terminated to the connector’s shield contact or to the enclosure ground point to maintain shielding continuity. After completing terminations and verifying connections, secure the enclosure cover and mount the junction box in the chosen indoor location.

Recommendations

Use the LANBERG PLC-6SL1-S with properly labelled shielded Cat6 cable and maintain consistent wiring standard (T568A or T568B) across the link. Ensure the shield is properly bonded to ground at least at one point, and avoid sharp bends or mechanical strain at the entry points. For optimal performance verify terminations with a network cable tester supporting shielded pairs.