Kingston Technology FURY 32GB 5600MT/s DDR5 CL40 SODIMM (Kit of 2) Impact PnP

Kingston FURY Impact DDR5 SODIMM brings DDR5 performance to laptops and small-form-factor systems in a compact 262-pin SO‑DIMM format. This 32GB kit (2x16GB) runs at an effective 5600MT/s (2800 MHz clock) with CL40 timings and 1.1V, offering higher bandwidth, lower power consumption, and on-die ECC for improved stability during demanding tasks and overclocking. Modules support Plug N Play automatic overclocking and are Intel® XMP 3.0 certified for selectable BIOS profiles up to published frequencies.

Advantages

The memory kit provides faster data transfer compared with DDR4 starting speeds, delivering improved multitasking, gaming and content creation responsiveness. Plug N Play modules can automatically reach their highest listed speed without manual BIOS configuration, while XMP 3.0 profiles enable precise overclocking via BIOS. Low operating voltage helps reduce power draw and heat, and on-die ECC increases data integrity and stability when running at higher speeds.

Suitable for

• Upgrading laptop memory for smoother multitasking
• Small-form-factor PCs and compact workstations
• Mobile content creation and video editing
• Gaming laptops that support DDR5 SO‑DIMM

Key specifications

• Capacity: 32 GB (2 x 16 GB)
• Memory type: DDR5 SODIMM, 262-pin
• Effective speed: 5600 MT/s (clock 2800 MHz)
• CAS Latency: CL40
• Voltage: 1.1 V
• Features: Intel® XMP 3.0 certified, Plug N Play automatic overclocking, on-die ECC
• Manufacturer part number (MPN): KF556S40IBK2-32
• EAN: 0740617331660
• Weight: 0.0168 kg

How to use

Power off your laptop or small-form-factor PC and disconnect it from mains. Open the memory compartment following the device manufacturer's instructions. Ground yourself to avoid electrostatic discharge, remove existing modules if necessary, and insert each 262-pin SODIMM into the slot at an angle, then press down until the side clips latch. If your modules support Plug N Play, they will automatically reach the highest listed speed; to use Intel® XMP 3.0 profiles, enable the desired XMP profile in BIOS/UEFI and save settings. Reassemble the device and power it on to confirm the system recognises the new memory.

Recommendations

Verify device compatibility with DDR5 SODIMM and supported speeds in your laptop or motherboard manual before installation. For best performance, install memory in matched pairs and keep BIOS/UEFI firmware up to date. Handle modules by the edges and avoid touching contacts.