Jump Cable IWH 075633, 30.0 mm² aluminium (copper-coated), 3.5 m

Jump Cable IWH 075633 is a 3.5 m starter cable with a 30.0 mm² aluminium conductor coated with copper. It is designed to transfer high current between vehicle batteries for jump-starting and workshop applications. The copper coating improves electrical conductivity and reduces corrosion compared with bare aluminium, making the cable suitable for most cars and light commercial vehicles.

Advantages

The copper-coated aluminium conductor provides better conductivity and corrosion resistance than uncoated aluminium while keeping weight lower than pure copper cables. At 30.0 mm² cross-section and 3.5 m length, the cable balances current capacity and reach for typical roadside jump-starts and garage use. Durable clamps and insulation allow repeated connections during emergency starts and maintenance tasks.

Suitable for

Key specifications

How to use

Park both vehicles close enough so the jumper cable can reach both batteries without stretching. Turn off ignitions and all electrical consumers. Connect the positive clamp to the positive terminal of the discharged battery, then to the positive terminal of the donor battery. Connect the negative clamp to the negative terminal of the donor battery and attach the other negative clamp to a metal chassis ground on the vehicle with the discharged battery, away from the battery and fuel system. Start the donor vehicle, then the vehicle with the discharged battery. After the engine starts, remove clamps in reverse order and let the restarted vehicle run to recharge its battery.

Recommendations

Inspect clamps and cable insulation before use; do not use if damaged. Follow vehicle manufacturer safety guidelines when jump-starting. Store the cable in a dry place and keep clamps clean to maintain good electrical contact.