Patch Cable Intos Cat6 S/FTP PiMF 250MHz RJ-45 to RJ-45, copper halogen-free, 1.5 m, red

Intos Cat6 S/FTP PiMF patch cable, 1.5 m, red, provides shielded Gigabit connectivity between two RJ-45 ports. The cable design combines an overall braided shield with individually foil‑shielded pairs (S/FTP PiMF) to suppress electromagnetic interference up to 250 MHz. Constructed with solid copper conductors (AWG27) and a halogen‑free jacket, this patch cable is suited for structured cabling, server cabinets and visible patching where safety and signal integrity are required. Both ends are fitted with molded RJ‑45 plugs with integrated kink protection, snap latch protection and a red color marking for fast identification; the connector also shows the cable length.

Advantages

The S/FTP PiMF shielding delivers stable, interference‑resistant transmission suitable for Gigabit Ethernet at frequencies up to 250 MHz. Solid copper conductors ensure low attenuation and reliable data throughput over the full length. The halogen‑free sheath reduces toxic gas emissions in case of fire, meeting safety needs for public and industrial environments. Molded RJ‑45 plugs with bend and snap protection increase mechanical durability, while the red‑marked plug and length indication streamline installation and cable management.

Suitable for

• Gigabit Ethernet connections (1000 Mbit/s) in LAN environments
• Patching between switches, patch panels and wall outlets in server rooms
• Structured cabling where enhanced EMI protection is required
• Environments requiring halogen‑free cabling such as public buildings and industrial sites

Key specifications

• Category: Cat6
• Shielding: S/FTP (overall braid + individually foil‑shielded pairs, PiMF)
• Frequency range: up to 250 MHz
• Data rate: supports up to 1000 Mbit/s (Gigabit Ethernet)
• Conductor: solid copper, AWG27
• Connectors: RJ‑45 male to RJ‑45 male, molded with kink and latch protection
• Jacket: halogen‑free (LSOH)
• Length: 1.5 m (length marking on connector)
• Wiring: 1:1 assignment according to EIA/TIA‑568B
• Color: red

How to use

Connect one RJ‑45 plug to the network device or patch panel port and the other plug to the switch, router or outlet. Ensure the plugs are fully inserted until the latch clicks to guarantee proper contact. Route the cable avoiding sharp bends and secure it to prevent tension at the connectors. The molded boot and kink protection help maintain reliable contact when the cable passes through cable ducts or ties. Use the red marking for quick visual identification in multi‑cable installations.

Recommendations

For best performance, keep cable runs within recommended patch lengths for horizontal and patch cabling, avoid running parallel to high‑voltage power lines and maintain bend radius greater than the connector boot. Use the length marking and red color to separate critical links from general cabling during maintenance or reconfiguration.