Hypertec 850861-HY networking cable Red 0.5 m Cat6 F/UTP (FTP)

The Hypertec 850861-HY Red 0.5m Cat6 F/UTP networking cable is a short patch cable built to support high-speed Ethernet connections. It follows the Cat6 specification and uses F/UTP shielding to minimise external electromagnetic interference. Both ends are fitted with standard RJ-45 connectors for compatibility with switches, routers, patch panels and network devices. The red jacket provides clear visual identification in crowded cabling environments.

Advantages

This Cat6 F/UTP cable offers improved signal integrity compared with unshielded cables, helping to maintain stable throughput over short runs. The 0.5 m length reduces excess slack in rack or desktop installations. Standard RJ-45 terminations ensure plug-and-play connectivity with a wide range of networking equipment. The coloured outer jacket supports quick identification and organised cable management without affecting performance.

Suitable for

Key specifications

How to use

Connect one RJ-45 end to the network port of a switch, router, patch panel or device and plug the other RJ-45 end into the corresponding port of the target device. Ensure connectors are fully seated to establish a reliable link. For rack installations, route the 0.5 m cable to avoid tension on the connectors and prevent kinks that could impair signal quality.

Recommendations

Use this 0.5 m Cat6 F/UTP cable for short, shielded connections where reduced electromagnetic interference is desirable. Avoid using the cable in runs longer than its length; for longer distances, select appropriately rated Cat6 or higher cables. Maintain connector cleanliness and avoid excessive bending near the plug to preserve performance.