Drill Bit Set Bosch Beton SDS+ 6/10/8 mm – Bosch SDS+ masonry bits, sizes 6 mm, 10 mm, 8 mm

Bosch Beton SDS+ drill bit set contains three masonry bits in diameters 6 mm, 10 mm and 8 mm designed for use with SDS+ rotary hammers. The bits are intended for drilling into concrete, masonry and natural stone where reliable penetration and durability are required. Each bit features the SDS+ shank for fast, tool-free insertion and secure retention in compatible rotary hammer chucks, providing steady drilling performance during repetitive construction and installation tasks.

Advantages

The set offers a compact selection of commonly used diameters for anchor, dowel and service-hole preparation. SDS+ compatibility ensures quick bit changes and reduced downtime. The masonry-optimized flute design removes dust efficiently from the hole, improving drilling speed and reducing bit wear. Hardened cutting edges deliver consistent results in dense materials while the solid shank construction increases resistance to bending and breakage under impact loads.

Suitable for

• Drilling anchor and dowel holes in concrete and masonry
• Creating service entry holes for cables and conduits
• Installation work in renovation and construction projects
• Light to medium structural fastening and fixture mounting

Key specifications

• Bit diameters: 6 mm, 8 mm, 10 mm
• Shank type: SDS+ shank for rotary hammers
• Intended materials: concrete, masonry, natural stone
• Cutting geometry: hardened cutting edges for masonry
• Flute design: dust evacuation flutes for efficient chip removal

How to use

Choose the bit diameter matching the required hole size and insert the SDS+ shank into the rotary hammer chuck until it engages. Select rotary hammer mode appropriate for drilling into concrete or masonry and apply steady axial pressure; avoid excessive side load. Start drilling at low speed to create a starter point if necessary, then proceed at recommended speed and controlled pressure. Periodically withdraw the bit to clear dust and prevent overheating when drilling deep holes. After use, remove the bit by pulling back the retention sleeve on the tool and store the bits in a protective case or holder.

Recommendations

Use appropriate personal protective equipment (safety glasses, dust mask and hearing protection) when drilling. For reinforcement or rebar detection, check the drilling area beforehand and adapt technique or use a different tool if necessary. Match bit diameter to anchor or dowel specifications and avoid excessive hammering in delicate finishes to reduce surface damage.