Drill bit (hammer) Bosch SDS plus-8X Clean 6×100×225 mm – 6 mm diameter, 100 mm working length

Bosch SDS plus-8X Clean 6×100×225 mm is a hammer drill bit designed for SDS‑plus rotary hammers. With a 6 mm diameter and 100 mm working length, this bit is built for drilling precise holes in concrete, masonry and natural stone. The SDS‑plus shank ensures secure tool retention and efficient power transfer in compatible rotary hammer systems, while the 225 mm total length provides additional reach for medium-depth drilling tasks.

Advantages

The drill bit features a geometry and tip design optimized for clean and accurate drilling in hard substrates, reducing breakouts and improving hole quality. Its SDS‑plus shank guarantees quick bit changes and consistent seating in the chuck. The combination of defined working length and extended total length allows controlled drilling depth and easier handling when working on vertical or overhead surfaces.

Suitable for

• Drilling holes for anchors and dowels in concrete and masonry
• Creating feed-through holes for cables or pipes in block and stone walls
• Professional and DIY tasks requiring 6 mm diameter holes at medium depth

Key specifications

• Diameter: 6 mm
• Working length (effective drilling depth): 100 mm
• Total length: 225 mm
• Shank type: SDS‑plus
• Intended materials: concrete, masonry, natural stone

How to use

Select a compatible SDS‑plus rotary hammer, fit the bit into the chuck until it locks, and set the tool to the hammer drilling mode recommended for masonry. Mark the drilling position, start at low speed to seat the tip, then apply steady pressure while allowing the tool to do the work. Withdraw the bit periodically to remove dust and improve cooling, and use appropriate protective equipment such as eye protection and a dust mask when drilling into concrete or stone.

Recommendations

For best results, use this Bosch SDS plus-8X Clean bit with a rotary hammer rated for SDS‑plus accessories and match drill speed and hammer impact settings to the substrate. Clean the hole between passes to maintain drilling efficiency and replace the bit when wear affects drilling accuracy or increases required feed force.