Drill Bit Bosch 5 mm Diameter, model 2608900155

Twist drill bit Bosch 5 mm Diameter, model 2608900155 is a general-purpose 5 mm drill designed for precise hole-making in a variety of standard materials. Compatible with handheld drills and drill drivers that accept 5 mm straight-shank bits, this Bosch twist drill provides consistent drilling performance for maintenance, assembly and light construction tasks where a clean 5 mm hole is required.

Advantages

The drill bit offers accurate 5 mm diameter holes with a twist-flute geometry that facilitates chip removal and stable drilling. Manufactured by a recognized brand, it provides uniform diameter control and balance for reduced wobble. The straight-shank design allows quick bit changes in standard chucks. Its construction supports repeated use in common materials while maintaining cutting edge integrity for routine tasks.

Suitable for

• Drilling 5 mm holes in wood
• Drilling 5 mm holes in plastics
• Drilling 5 mm holes in soft metals (e.g., aluminium)
• General maintenance and assembly work with handheld drills

Key specifications

• Diameter: 5 mm
• Type: Twist/drill bit with straight shank
• Compatibility: Standard chucks on handheld drills and drill drivers that accept 5 mm bits
• Typical uses: General-purpose drilling for maintenance, assembly and light construction

How to use

Insert the 5 mm twist drill into a compatible drill chuck and tighten securely. Select an appropriate drill speed and feed rate according to the material: lower speeds for metals, moderate speeds for wood and plastics. Apply steady axial pressure and allow the bit to cut without forcing; withdraw periodically to clear chips when drilling deeper holes. After use, clean chips from the flutes and store the bit in a dry location to prevent corrosion.

Recommendations

Use suitable personal protective equipment (safety glasses, gloves if appropriate) and secure workpieces with clamps. For metals, consider using cutting lubricant and reduced speed to extend bit life; for wood and plastics, use a backing board to prevent tear-out. Inspect the bit for wear before use and replace it if the cutting edge is damaged or performance declines.