CBO AOC SFP+ BlueOptics BO353503J50M Netgear AXC7650 50m fiber active optical cable SFP+ 10Gbps

CBO AOC SFP+ BlueOptics BO353503J50M Netgear AXC7650 50m fiber active optical cable SFP+ 10Gbps is a factory-terminated active optical cable designed for direct 10 Gbps SFP+ links between switches, servers and storage devices. The cable integrates optical transceivers at both ends, eliminating the need for separate SFP+ modules and providing a compact, low-power solution for short- to mid-range data centre and network interconnects. With a 50 m length and single-cable deployment, it supports high-speed, low-latency transmission over multimode or compatible optical environments while reducing electromagnetic interference risks compared with copper solutions.

Advantages

The AOC design offers a plug-and-play SFP+ connection that simplifies installation and reduces component count by removing the need for separate transceivers. Active optical construction provides low insertion loss and consistent 10 Gbps performance across the full 50 m length, while maintaining low power consumption and thermal footprint. Compatibility with BlueOptics BO353503J50M and Netgear AXC7650 form factors ensures interoperability with devices that accept SFP+ optical interfaces. The fiber medium provides immunity to electromagnetic interference and supports stable signal integrity for high-density rack deployments.

Suitable for

• 10 Gbps uplinks between top-of-rack switches and aggregation switches
• Server-to-switch and storage-to-switch interconnects in data centres
• High-density network environments where space and power savings are required
• Environments requiring interference-free links and low-latency transmission

Key specifications

• Connector type: SFP+ form-factor active optical cable ends
• Nominal data rate: 10 Gbps per link
• Cable length: 50 metres
• Optical medium: active multimode-compatible fibre assembly
• Latency: low propagation delay suitable for data centre use
• Power: integrated active modules with low power draw compared to separate transceivers
• Operating environment: designed for indoor, rack and conduit installations

How to use

Install the AOC by inserting the SFP+ connectors into compatible SFP+ ports on the two devices to be linked, ensuring the connectors click into place. Verify link status on each device and configure network settings such as speed, duplex and VLANs as required by your infrastructure. Handle the fibre cable by the reinforced jacket and connector housings, avoid tight bends and secure the cable along rack management paths to prevent strain. No separate optical modules or patch cords are required; the cable provides an integrated optical link ready for immediate use once connected and recognised by the host devices.

Recommendations

Maintain bend radii above the manufacturer’s minimum, avoid exposure to moisture and direct sunlight, and route the cable using cable management accessories to prevent stress. Confirm compatibility with your switch or server vendor’s supported SFP+ AOC list where applicable and check firmware or driver updates that may affect optical link negotiation.