SFP+ Direct Attach Cable CBO Fujitsu S26361-F3873-E500, 30 m, DAC

Direct Attach Cable (DAC) SFP+ from CBO, compatible with Fujitsu model S26361-F3873-E500, is a 30 meter passive SFP+ copper cable designed to provide a fixed 10 Gbps connection between SFP+ ports. The cable is intended for short-range high-throughput links in data centers and server rooms, suitable for rack-to-rack and intra-rack interconnects where a reliable, low-latency copper connection is required. It offers a simple solution for connecting switches, servers and storage systems equipped with SFP+ interfaces.

Advantages

This DAC SFP+ cable delivers a stable 10 Gbps link with minimal latency and predictable performance for short-range connections. Being a passive copper assembly, it does not require external power or transceivers, which simplifies installation and reduces component count. The 30 m length supports flexible placement within racks and between nearby racks while maintaining signal integrity for typical data center topologies.

Suitable for

• 10 Gbps connections between switches and servers
• Rack-to-rack or intra-rack interconnects in data centers
• Connections between storage arrays and hosts with SFP+ ports
• Short-range, low-latency network links in server rooms

Key specifications

• Interface: SFP+ to SFP+
• Data rate: 10 Gbps
• Type: Passive Direct Attach Copper Cable (DAC)
• Length: 30 m
• Compatibility: Compatible with Fujitsu S26361-F3873-E500 SFP+ ports
• Typical use: Rack-to-rack and intra-rack short-range connections

How to use

Install the DAC by inserting each SFP+ connector into the corresponding SFP+ port on network switches, servers or storage devices until the connector latches. Ensure equipment is powered down or follow hot-plug policies of your hardware vendor when connecting during operation. Verify link status in device management interfaces after insertion to confirm the 10 Gbps connection is established.

Recommendations

Use this passive 30 m DAC for short-distance interconnects within the same rack or between adjacent racks. Avoid sharp bends and excessive pulling tension on the cable to preserve signal integrity. Follow your equipment vendor’s guidelines for hot-plugging and supported SFP+ direct attach modules to ensure full compatibility and performance.