BlueOptics SFP-AOC-10G-25M-UQ-BO InfiniBand/fibre optic cable SFP+ 25m Male/Male

The BlueOptics SFP-AOC-10G-25M-UQ-BO InfiniBand/fibre optic cable SFP+ 25m Male/Male is a 25-metre active optical cable engineered for high-speed short-reach links. With SFP+ interfaces on both ends, this single-cable solution provides a compact, low-power alternative to transceiver-plus-patch-cord assemblies and is suitable for connecting switches, servers and storage within data centres and enterprise racks. The cable delivers 10 Gigabit-class performance with the signal integrity and low latency expected from fibre-based interconnects.

Advantages

This AOC offers predictable transmission behaviour and immunity to electromagnetic interference due to its optical design, while keeping a small, flexible form factor for clean cable management. The integrated SFP+ modules eliminate separate transceivers and patch cords, simplifying installation and reducing points of failure. Its 25 m length enables convenient inter-rack and intra-room connections without additional hardware and with low power consumption compared with equivalent copper solutions.

Suitable for

• Interconnecting SFP+ ports on switches and servers within data centres
• High-speed links between storage arrays and host systems
• Short-reach InfiniBand and fibre optic links in enterprise racks
• Scenarios requiring low-latency, EMI-resistant cabling

Key specifications

• Connector type: SFP+ male on both ends
• Length: 25 metres
• Data rate: up to 10 Gbit/s
• Transmission medium: active optical cable (single fibre pair)
• Form factor: hot-pluggable SFP+ integrated modules
• Typical use: short-reach/medium-reach rack-to-rack or within-room links

How to use

Install the cable by inserting each SFP+ end into the corresponding SFP+ ports on your networking devices until the module latches. Ensure devices are powered down or follow hot-swap procedures recommended by the equipment manufacturer. After insertion, verify link status using device LEDs or management interfaces and confirm negotiated link speed at 10 Gbit/s. Route the cable to avoid tight bends and secure it within the rack to prevent strain on connectors.

Recommendations

Use this cable for short- to medium-distance optical interconnects inside data centres or equipment rooms. Avoid bending the cable beyond manufacturer-specified minimum bend radius and protect connector endfaces from dust when not in use. For compatibility, confirm that the host devices support SFP+ AOC modules and 10 Gbit/s operation.