SFP+ Active Optical Cable CBO Viavi SFP-AOC-10G-50M 10Gbps 50m

The SFP+ Active Optical Cable CBO Viavi SFP-AOC-10G-50M 10Gbps 50m is a factory-terminated SFP+ duplex optical link designed to provide 10 Gigabit-per-second connectivity over a 50-meter channel. It uses SFP+ connectors on both ends for direct attachment to compatible switches, servers and storage devices, offering low latency, immunity to electromagnetic interference and simplified cabling compared with copper alternatives. The cable is intended for short-reach high-speed links where consistent 10G performance and signal integrity are required.

Advantages

This active optical cable provides stable 10Gbps throughput with reduced signal attenuation across the full 50 m length and lower power consumption than many active electrical solutions. Because it is an optical medium, it is not affected by electromagnetic interference and eliminates the need for separate transceiver modules, simplifying installation and inventory. The SFP+ form-factor ensures compatibility with equipment that supports direct-attach SFP+ optics, while the pre-terminated design reduces potential errors during deployment.

Suitable for

• Top-of-rack and end-of-row connections in data centres
• Interconnects between 10G switches and servers
• Direct links for storage arrays and rack-mounted appliances
• Telecom indoor short-reach aggregation and distribution links

Key specifications

• Data rate: 10 Gbps duplex
• Maximum reach: 50 metres over OM3/OM4 multimode optical fibre within the AOC assembly
• Connector type: SFP+ on both ends, hot-pluggable
• Medium: active optical cable (factory-terminated)
• Latency: low propagation delay suitable for latency-sensitive applications
• EMC: immune to electromagnetic interference by virtue of optical transmission
• Power: integrated active components require modest power supplied via SFP+ host ports

How to use

Install the SFP+ ends into the SFP+ cages of compatible switches, servers or storage devices while systems are powered according to the equipment vendor’s hot-plug guidance. Ensure both ends are fully seated and that link LEDs or management interfaces indicate an active 10G connection. No separate transceivers or fibre patching is required; route the cable to avoid sharp bends and mechanical stress. If a device requires explicit configuration for an SFP+ link, follow the device documentation to enable or verify the 10G interface.

Recommendations

For reliable operation, use in environments within the equipment-specified temperature range, avoid tight bends below the cable minimum bend radius, and verify compatibility with the host equipment vendor for SFP+ AOC modules. Confirm link speed and duplex settings in management interfaces when integrating with mixed-speed networks.