BlueOptics QSFP-AOC-50M-MV-BO InfiniBand/fibre optic cable 1 m Male/Male

The BlueOptics QSFP-AOC-50M-MV-BO InfiniBand/fibre optic cable 1 m Male/Male is a one‑metre active optical cable with QSFP connectors designed for high‑speed links in data centers and enterprise networks. It provides a compact, low‑power alternative to transceiver-plus-patch‑fibre assemblies by integrating the optical transceivers into the cable ends. The cable supports reliable, low‑latency data transmission between compatible QSFP ports and is suitable for short‑reach connections where space and power efficiency are important.

Advantages

This active optical cable combines QSFP form‑factor connectivity with the electrical simplicity of a direct cable, reducing complexity in rack cabling and eliminating the need for separate transceiver modules and patch cords. Its one‑metre length is optimized for top‑of‑rack and adjacent‑rack connections, minimizing signal loss and maintaining consistent throughput. The integrated optics lower power consumption compared with some pluggable solutions and provide a sealed optical path that reduces sensitivity to dust and handling.

Suitable for

• Short‑reach interconnects between switches, routers, and server QSFP ports
• High‑performance computing (HPC) clusters using InfiniBand links
• Top‑of‑rack cabling in dense data center racks
• Low‑latency storage area network (SAN) connections

Key specifications

• Connector type: QSFP to QSFP, male/male
• Cable type: Active optical cable (AOC)
• Length: 1 meter
• Application: InfiniBand and fibre optic high‑speed data links
• Performance: Designed for multi‑lane, high‑bandwidth, low‑latency links
• Physical attributes: Lightweight, flexible optical cable suitable for dense rack environments

How to use

Insert each QSFP connector into compatible QSFP ports on your network devices, ensuring proper alignment and a firm, but not excessive, push until the connector latches. Verify that both ends are fully seated and that device LEDs or management interfaces report link status. Use the cable for one‑metre connections where direct QSFP‑to‑QSFP interconnection is required; no separate transceivers or patch fibres are necessary. Handle the cable by the connector bodies and avoid tight bends near the terminations to preserve optical performance.

Recommendations

Store and route the cable with a bend radius consistent with manufacturer guidance, avoid mechanical stress on the connectors, and ensure ports are powered down or in a safe state if your equipment vendor recommends it before insertion or removal. Confirm compatibility with device QSFP port specifications and firmware to ensure proper link negotiation and performance.