BlueOptics QSFP-AOC-15M-MA-BO InfiniBand fibre optic cable 15m Male/Male

The BlueOptics QSFP-AOC-15M-MA-BO InfiniBand fibre optic cable 15m Male/Male is a 15-metre active optical cable designed for high-speed interconnects in data centres and high-performance computing environments. It uses QSFP form-factor connectors on both ends and is intended to provide low-latency, high-bandwidth links between switches, servers and storage systems. The cable is factory-terminated and pre-tested to ensure consistent optical performance over the specified length.

Advantages

This active optical cable offers high aggregate bandwidth and low power consumption compared with equivalent copper solutions, while eliminating the need for separate transceivers. Its QSFP-to-QSFP connectivity simplifies rack and pod-level cabling and reduces installation time. The 15 m length provides the reach required for connections across racks or between adjacent rows without signal degradation typical of longer copper runs.

Suitable for

• Interconnects between InfiniBand-enabled switches and routers
• Server-to-switch and server-to-storage links in HPC clusters
• Data centre top-of-rack and middle-of-row cabling where QSFP ports are available
• Latency-sensitive applications requiring consistent optical transmission

Key specifications

• Connector type: QSFP (male) on both ends
• Optical type: Active optical cable (AOC)
• Length: 15 metres
• Application: InfiniBand high-speed interconnects
• Transmission: Designed for low-latency, high-bandwidth data transfer
• Termination: Factory-terminated, pre-tested for consistent performance

How to use

Install the cable by aligning each QSFP connector with the corresponding QSFP port on your network device and pressing until the connector latches. Ensure devices are powered down or follow hot-plug procedures recommended by the equipment manufacturer if connecting live. After insertion, verify link status and performance using your switch or host diagnostics to confirm the optical connection is active and operating at the expected speed.

Recommendations

Avoid sharp bends and kinks in the cable; maintain the manufacturer’s minimum bend radius and route the cable away from sources of mechanical stress and heat. Use proper cable management in racks to prevent strain on the QSFP connectors, and follow your equipment vendor’s guidance for firmware and link negotiation settings when deploying InfiniBand links.