BlueOptics QSFP-AOC-15M-DL-BO InfiniBand fibre optic cable 15m Male/Male

The BlueOptics QSFP-AOC-15M-DL-BO InfiniBand fibre optic cable 15m Male/Male is a 15-metre active optical cable designed for high-speed, low-latency data links in data centre and enterprise networking environments. Equipped with QSFP connectors on both ends, this cable supports InfiniBand interconnects between switches, servers and storage systems. Its enclosed optical design provides electrical isolation and predictable signal integrity for dense rack-to-rack and intra-rack connections.

Advantages

This BlueOptics QSFP-AOC-15M-DL-BO cable offers high bandwidth with low latency suitable for demanding aggregation and compute fabrics. The active optical construction reduces electrical interference and heat compared with equivalent copper assemblies, while the 15 m length enables flexible placement of networking equipment across racks or between adjacent aisles. QSFP-to-QSFP terminations ensure straightforward compatibility with equipment adopting QSFP form-factor ports.

Suitable for

• High-density data centre switch-to-switch connections
• Server-to-switch links in compute clusters
• Links between storage arrays and host adapters
• Short to mid-reach interconnects where optical isolation is required

Key specifications

• Type: Active Optical Cable (AOC)
• Connector type: QSFP (male) on both ends
• Standard: InfiniBand-compatible transmission
• Length: 15 metres
• Transmission: multimode optical link for short to mid-range data centre distances
• Latency: low-latency optical interconnect suitable for high-performance fabrics
• Environment: designed for data centre rack and cable-management deployment

How to use

Install the BlueOptics QSFP-AOC-15M-DL-BO by inserting each QSFP connector into the corresponding QSFP port on your switch, server or host adapter until the retention mechanism engages. Ensure both ends are fully seated and that optical ports are compatible with InfiniBand signalling on your devices. Route the cable following standard cable-management practices to avoid tight bends and to maintain the specified bend radius. No external transceivers are required because the optical transceivers are integrated into the cable assemblies.

Recommendations

Verify port compatibility and firmware support on active equipment before deployment. Maintain clean connector interfaces, avoid sharp bends, and secure the cable to prevent strain on QSFP ports. Use the 15 m length to span racks or connect adjacent aisles while keeping excess slack coiled neatly within the rack to preserve signal integrity.