BlueOptics PAN-QSFP-AOC-7M-BO InfiniBand Fibre Optic Cable 1m QSFP Male/Male

The BlueOptics PAN-QSFP-AOC-7M-BO InfiniBand Fibre Optic Cable 1m QSFP Male/Male is a 1 metre active optical cable (AOC) with QSFP connectors on both ends designed for short-range, high-speed links. It implements QSFP-to-QSFP connectivity and supports multimode fibre transmission suitable for 40G applications. The cable integrates transceivers in each connector to convert electrical signals to optical signals and back, enabling direct high-throughput connections between compatible network devices in data centres and high-performance computing environments.

Advantages

The cable provides a compact, factory-terminated connection that reduces the need for separate transceivers and patching, simplifying rack and cabling layouts. Its active optical design supports reliable 40G data rates over short distances with low latency, while QSFP male connectors ensure interoperability with equipment that accepts QSFP modules following common MSA conventions. The single-metre length minimizes excess cable slack and improves airflow and cable management in dense installations.

Suitable for

• Short-reach 40G links between switches and routers in data centres
• High-performance computing clusters requiring InfiniBand or 40G connectivity
• Direct connections between storage systems and servers supporting QSFP
• Environments where reduced rack cabling and low latency are important

Key specifications

• Connector type: QSFP male to QSFP male
• Length: 1 metre
• Type: Active Optical Cable (AOC) with integrated transceivers
• Supported link technology: InfiniBand and 40G Ethernet (40GBASE-SR4)
• Fibre type: multimode fibre
• Typical use case: short-range, high-speed data transmission

How to use

Install the BlueOptics PAN-QSFP-AOC-7M-BO by inserting each QSFP connector into the QSFP port of the corresponding devices until it clicks into place. Ensure both devices support QSFP AOC connectivity and the relevant 40G/InfiniBand protocols. No separate transceivers or patch cables are required; the cable is ready to use once connected. Verify link status indicators on the connected equipment to confirm an active connection and check device configuration for appropriate port speed and protocol settings.

Recommendations

Handle the cable by the connector housings and avoid tight bends or sharp kinks in the fibre. Keep the connector end faces clean and protected from dust when not in use. Use the 1 m length for direct device-to-device links or short patching within racks to maintain good airflow and minimize cable clutter. Confirm compatibility with the target hardware’s supported module list before deployment.