DAC cable CBO JNP-100G-DAC-3M-BL — 3 m QSFP28 male, 100 Gbit/s

Direct Attach Copper (DAC) cable CBO JNP-100G-DAC-3M-BL is a 3-meter QSFP28 male assembly that supports 100 Gbit/s links. It is intended for short-reach interconnects in data centers and high-performance network environments, providing a low-latency, low-power electrical connection between QSFP28 ports on switches, routers and servers.

Advantages

This 3 m QSFP28 cable delivers 100 Gbit/s bandwidth with minimal latency and reduced power consumption compared with active optical solutions for short distances. The copper direct-attach design simplifies setup by offering a single, ready-to-use cable with integrated connectors and predictable electrical performance. Its fixed length and robust construction reduce signal loss and maintain stable throughput in dense rack environments.

Suitable for

Key specifications

How to use

Install the cable by inserting each QSFP28 connector into the corresponding QSFP28 port on the devices until the latch engages. Ensure both ends are seated firmly and ports are powered off or follow hot-plug guidelines provided by your equipment vendor if connecting live. Verify link status through device LEDs or management interfaces and confirm negotiated speed at 100 Gbit/s. Avoid sharp bends and secure the cable to prevent strain on connectors.

Recommendations

Use this 3 m DAC cable for intra-rack or adjacent-rack connections where 100 Gbit/s performance is required and optical transceivers are not necessary. Keep the cable run within recommended bend radius limits, avoid running near high-heat sources, and check compatibility with QSFP28 ports on your network equipment to ensure proper electrical signalling and link negotiation.