CBO SFP+ Passive Optical Cable Broadcom SFP-AOC-10G-10M 10 m

The CBO SFP+ Passive Optical Cable Broadcom SFP-AOC-10G-10M 10 m is a factory-terminated active optical cable designed for 10 Gigabit SFP+ connections. This AOC provides a direct fiber link between compatible SFP+ ports without the need for separate transceiver modules, supporting short-reach interconnects in data centers, server-to-switch links and high-speed switching environments. The cable combines a compact form factor with low latency and plug-and-play operation to simplify rack-level cabling and reduce component count.

Advantages

The passive SFP+ optical cable delivers full 10G signaling over a 10 meter fiber link while eliminating the requirement for discrete SFP+ transceivers. Its factory-terminated design ensures consistent optical performance and easy insertion into SFP+ ports. The solution provides reduced power consumption compared to active copper solutions, minimal signal latency and a tidy cabling footprint suitable for dense rack deployments.

Suitable for

• Short-reach data center interconnects
• Server-to-switch or switch-to-switch 10 Gigabit links
• High-density rack cabling in enterprise networks
• Low-latency storage and compute cluster connections

Key specifications

• Interface type: SFP+ to SFP+ optical cable
• Data rate: 10 Gbps
• Cable length: 10 meters
• Cable type: factory-terminated optical AOC
• Form factor: SFP+ connector housing
• Typical use: short-reach multiport interconnects

How to use

Install the cable by inserting each SFP+ connector into the corresponding SFP+ port on your network devices until the latch engages. No separate transceivers are required, and the link is normally recognized by network equipment automatically. Verify device compatibility with SFP+ port firmware and vendor compatibility lists if necessary, then enable the 10G interface in your switch or host operating system to begin traffic forwarding.

Recommendations

Use the cable in controlled data center environments and avoid tight bends or sharp kinks to maintain optical performance. Route the cable alongside other fiber runs with appropriate bend radius and secure it to avoid strain on connectors. Confirm compatibility with your switch or server vendor for SFP+ AOC solutions and ensure firmware supports passive optical cables for reliable link negotiation.