CBO AOC SFP+ Active Optical Cable for Palo Alto Networks SFP-AOC-10G-20M 10G 20m

The CBO AOC SFP+ Active Optical Cable for Palo Alto Networks SFP-AOC-10G-20M 10G 20m is an active optical direct-attach solution that supports 10 Gbps data transmission over a 20-metre multimode optical link in an SFP+ form factor. Designed for compatibility with Palo Alto Networks SFP+ ports, this AOC integrates transceiver electronics and a fiber cable into a single, hot-pluggable module, reducing the need for separate transceivers and fiber patch cords in short-to-medium reach interconnects.

Advantages

This CBO AOC delivers a stable 10 Gbps link with low latency and reduced power consumption compared with equivalent copper solutions for similar distances. The integrated design simplifies installation and inventory management by combining connector and cable into one SFP+ module, and the 20 m length provides flexibility for rack-to-rack and aisle connections in data centers and enterprise network rooms. The active optical construction ensures signal integrity over multimode fiber and mitigates electromagnetic interference in dense deployments.

Suitable for

• Server-to-switch and switch-to-switch interconnects within data centers
• Storage area network links and SAN aggregation panels
• Top-of-rack to aggregation switch connections in enterprise networks
• High-density network environments requiring compact SFP+ form-factor cabling

Key specifications

• Data rate: 10 Gbps
• Form factor: SFP+ integrated active optical cable
• Link length: 20 metres over multimode fiber
• Connector type: SFP+ module ends (hot-pluggable)
• Optical interface: multimode fiber optimized for short-to-medium reach
• Typical power consumption: lower than equivalent VCopper solutions (active optical design)

How to use

Insert each SFP+ end of the active optical cable into compatible SFP+ ports on your Palo Alto Networks devices or other supported network equipment while the ports are in their normal operating state; the module is hot-pluggable and does not require separate transceivers or external optics. Ensure the ports are configured for 10 Gbps operation if manual settings are required by the equipment. Route the cable to avoid tight bends and mechanical strain; maintain the specified minimum bend radius for multimode fiber to preserve signal quality.

Recommendations

Verify firmware and port compatibility with your Palo Alto Networks hardware before deployment, and test links after installation to confirm link status and performance. Use appropriate cable management to prevent excessive bending or compression, and avoid running the AOC alongside high-voltage power lines to minimize potential interference in dense equipment environments.