CBO active optical cable SFP28 100G model 740-084667 for high-speed 100 Gigabit connections

The CBO active optical cable SFP28 100G model 740-084667 is an SFP28-form-factor active optical cable designed for 100 Gigabit Ethernet links. With a factory-terminated SFP28 connector on each end, this CBO AOC enables direct 100G connections between compatible SFP28 ports on switches, servers and network interface cards. It is intended for short- to medium-range, high-bandwidth links in data center and enterprise network environments where low latency, high throughput and immunity to electromagnetic interference are important.

Advantages

This BlueOptics active optical cable delivers a compact, energy-efficient alternative to discrete transceivers plus fiber assemblies. It provides native 100G bandwidth with lower power consumption compared with some copper direct-attach options and eliminates the need for separate fiber patching and transceiver inventory. The AOC design reduces susceptibility to EMI and crosstalk and simplifies port-to-port cabling with a single factory-tested assembly for predictable link performance.

Suitable for

• High-speed uplinks between top-of-rack and aggregation switches
• Server-to-switch connections in virtualization and high-performance computing environments
• Short- to medium-reach interconnects inside data center racks and between adjacent racks
• Network interface card (NIC) to switch links requiring 100G throughput

Key specifications

• Form factor: SFP28 active optical cable with SFP28 plugs on both ends
• Nominal data rate: 100 Gigabit Ethernet
• Optical type: Active optical cable (AOC) using optical fiber and integrated transceivers
• Typical reach: short- to medium-range links suitable for in-rack and adjacent-rack connectivity
• Latency: low latency design suitable for high-performance networking
• EMI immunity: inherent resistance to electromagnetic interference compared with copper solutions
• Compatibility: designed for use with equipment that supports SFP28 100G AOC connections

How to use

Install the CBO active optical cable by inserting each SFP28 connector into compatible SFP28 ports on the two devices to be linked. Ensure devices are powered off or follow live-insertion procedures recommended by the equipment manufacturer. Verify that the host devices recognize a 100G link and confirm link parameters via switch or server management interfaces. No separate transceivers, patch cords or additional fiber termination are required; the cable is a single factory-terminated assembly.

Recommendations

Route the cable to avoid tight bends and mechanical stress; respect the minimum bend radius specified by the cable supplier. Use in environments where compatible SFP28 100G ports are supported and firmware or driver compatibility has been validated. For longer runs or different reach requirements, evaluate alternative fiber or transceiver options.